Ford  Escape 2008-2012
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   YELLOW/RED (+) (125AMP)   @ SMART JUNCTION BOX BLACK 1-PIN PLUG
 STARTER  BLUE/WHITE (+)  @ IGNITION SWITCH HARNESS, BLACK 7-PIN PLUG, PIN 7
 STARTER 2  N/A  
 IGNITION 1  WHITE/ORANGE (+)  @ IGNITION SWITCH HARNESS, BLACK 7-PIN PLUG, PIN 1
 IGNITION 2  N/A  
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  VIOLET/GREEN (+)  @ IGNITION SWITCH HARNESS, BLACK 7-PIN PLUG, PIN 6
 ACCESSORY/HEATER BLOWER 2  N/A  
 KEYSENSE  BLUE/GRAY (+)  @ IGNITION SWITCH HARNESS, BLACK 7-PIN PLUG, PIN 5
 PARKING LIGHTS ( - )  N/A  
 PARKING LIGHTS ( + )  VIOLET/WHITE (+)  LOW IN DRIVERS KICK PANEL or SJB, (BLACK 32-PIN PLUG (D) PIN 31, Note #2
 POWER LOCK  BLUE/GREEN (TYPE B)  IN DRIVERS KICK PANEL or SJB, (GRAY 26-PIN PLUG (C) PIN 17, Note #2
 POWER UNLOCK  YELLOW/VIOLET (TYPE B)  IN DRIVERS KICK PANEL or SJB, (GRAY 26-PIN PLUG (C) PIN 4, Note #2
 DOOR TRIGGER  GRAY/VIOLET (+)  DRIVERS KICK PANEL
 DOMELIGHT SUPERVISION  GRAY/PURPLE (-)  IN DRIVERS KICK PANEL or SJB, (GRAY 14-PIN PLUG (A) PIN 9, Note #2
 TRUNK RELEASE  BROWN (-) (Liftgate), BROWN/YELLOW (-) (Glass)  IN DRIVERS KICK PANEL or SJB, (GRAY 26-PIN PLUG (C) PINS 7 and 20, Note #2
 SLIDING POWER DOOR  N/A  
 HORN  BROWN (-)  @ HORN SWITCH or SJB, (BLACK 52-PIN PLUG (B) PIN 41, Note #2
 TACH  Any wire NOT BLUE (AC)  @ Any FUEL INJECTOR
 WAIT TO START LIGHT  N/A  
 BRAKE  PURPLE/WHITE (+)  @ BRAKE SWITCH or SJB, (BLACK 56-PIN PLUG (B) PIN 40, Note #2
 FACTORY ALARM DISARM   N/A  
 ANTI-THEFT  FORD'S TRANSPONDER ANTI-THEFT TRANSPONDER SYSTEM, SEE NOTE #1  @ IGNITION SWITCH TUMBLER
 EXTRA INFORMATION
 NOTE #1: This vehicle is equipped with a Special Anti-theft key, to remote start you will need a Bypass module 791,(use this module IF you have a extra ignition key to place inside the 791 to remote start, if you do not have an extra key to use or wish not to have a key placed inside this bypass module, we OFFER a KEYLESS INTERFACE BYPASS MODULE that does not require a key to be placed inside the bypass modlue, this is Part # PKALL or PKFM, either one will work, to order, go to the INTERFACE BYPASS MODULE PAGE on this website. If 2011 or newer and shaft of key has "SA" stamped into metal this is Fords new 80bit key and will require a PKTX interface module. Note #2: the SJB, (Smat Junction Box) is located in the Front of the Center console, Passenger Side.