Ford  Crown Victoria 1998-2002
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   BROWN (+) and LIGHT GREEN (+) or YELLOW   @ IGNITION SWITCH HARNESS
 STARTER  WHITE/PINK (+)  @ IGNITION SWITCH HARNESS
 STARTER 2  N/A  
 IGNITION 1  BROWN/PINK (+)  @ IGNITION SWITCH HARNESS
 IGNITION 2  PINK/BLACK (+)  @ IGNITION SWITCH HARNESS
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  GREY/YELLOW (+)  @ IGNITION SWITCH HARNESS
 ACCESSORY/HEATER BLOWER 2  BLACK/GREEN (+)  @ IGNITION SWITCH HARNESS
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  N/A  
 PARKING LIGHTS ( + )  BROWN (+)  @ LCM See, NOTE #3
 POWER LOCK  PINK/YELLOW (TYPE C), See NOTE #2  IN DRIVERS DOOR HARNESS
 POWER UNLOCK  PINK/LIGHT GREEN (TYPE C), See NOTE #2  IN DRIVERS DOOR HARNESS
 DOOR TRIGGER  DARK BLUE (-) and BLACK/ORANGE (-) Use both, See NOTE #6  @ LCM, See NOTE #3
 DOMELIGHT SUPERVISION  DARK BLUE (+)  @ LCM, See NOTE #3
 TRUNK RELEASE  PURPLE/YELLOW (5-Wire), See NOTE #4, (Requires Part #775 Relay)  IN DRIVERS DOOR HARNESS
 SLIDING POWER DOOR  N/A  
 HORN  DARK BLUE (-)  @ LCM, See NOTE #3
 TACH  WHITE/PINK (AC)  @ PCM, See NOTE #5
 WAIT TO START LIGHT  N/A  
 BRAKE  LIGHT GREEN (+)  @ SWITCH ABOVE BRAKE PEDAL
 FACTORY ALARM DISARM   N/A  
 ANTI-THEFT  FORD'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1  @ IGNITION SWITCH TUMBLER
 EXTRA INFORMATION
 NOTE #1: Some of these vehicles use a Special Anti-theft key to remote start you will need a Bypass module 791,(use this module IF you have a extra ignition key to place inside the 791 to operate, if you do not have an extra key to use or wish not to have a key placed inside this bypass module, we OFFER a KEYLESS INTERFACE BYPASS MODULE that does not require a key to be placed inside the bypass modlue, this is Part # PKALL or P KFM, either one will work, to order, go to the INTERFACE BYPASS MODULE PAGE on this website. NOTE #2: If vehicle is equipped with a FACTORY KEYLESS ENTRY System, then the vehicle has a TYPE B Door Locking System, vehicles without FACTORY KEYLESS ENTRY, have a TYPE C Door Locking System. Vehicles with the KEY PAD on the Door is considered to have KEYLESS ENTRY. NOTE #3: The LCM (Lighting Control Module) is located to the RIGHT of the STEERING COLUMN, with its harness accessable between the steering column and the LCM. NOTE #4: This vehicle uses a 5-Wire Trunk Release system, and will require a extra relay part #775, to connect, See DIAGRAM NOTE #5: The PCM (Power Control Module) is located under the HOOD, on the drivers side of the BRAKE MASTER CYLINDER. NOTE #6: this vehicle has 2 DOOR TRIGGER wires, when connecting to an ALARM SYSTEM, use both DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM.