Ford  Contour 1996-1997
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   RED (+)   @ IGNITION SWITCH HARNESS
 STARTER  GRAY/WHITE (+)  @ IGNITION SWITCH HARNESS
 STARTER 2  N/A  
 IGNITION 1  GREEN (+)  @ IGNITION SWITCH HARNESS
 IGNITION 2  N/A  
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  YELLOW (+)  @ IGNITION SWITCH HARNESS
 ACCESSORY/HEATER BLOWER 2  N/A  
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  N/A  
 PARKING LIGHTS ( + )  RED/BLUE (+) 2 wires, Use both, See NOTE #2  @ HEADLIGHT SWITCH, See DIAGRAM
 POWER LOCK  WHITE/GREEN (TYPE A)  HIGH in DRIVERS KICK PANEL
 POWER UNLOCK  YELLOW/GREEN (TYPE A)  HIGH in DRIVERS KICK PANEL
 DOOR TRIGGER  WHITE/BLACK (-) and WHITE/RED (-) USE BOTH, See NOTE #3  @ FUSE BOX, See DIAGRAM
 DOMELIGHT SUPERVISION  WHITE/BLACK (-), (Requires Part #775 Relay)  @ FUSE BOX
 TRUNK RELEASE  ORANGE/GREEN (+)  @ TRUNK RELEASE SWITCH
 SLIDING POWER DOOR  N/A  
 HORN  BLACK/BLUE (-)  @ STEERING COLUMN HARNESS
 TACH  WHITE/BLACK (AC)  @ PCM, Pin 48, See NOTE #4
 WAIT TO START LIGHT  N/A  
 BRAKE  ORANGE/YELLOW(+)  @ SWITCH ABOVE BRAKE PEDAL
 FACTORY ALARM DISARM   NA  
 ANTI-THEFT  FORD'S TRANSPONDER ANTI-THEFT SYSTEM, SEE NOTE #1  @ IGNITION SWITCH TUMBLER
 EXTRA INFORMATION
 NOTE #1: This vehicle may be equipped with FORD'S TRANSPONDER ANTI-THEFT SYSTEM and will require Part # 791 BYPASS MODULE and an extra Ignition Key for Remote Starting, to order go to the SECURITY BYPASS MODULE PAGE on this website. NOTE #2: this vehicle uses 2 PARKING LIGHT wires that will require 2 extra Relay part#775 to connect, See DIAGRAM NOTE #3: this vehicle has 2 DOOR TRIGGER wires, when connecting to an ALARM SYSTEM use both DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM NOTE #4: The PCM (Powertrain Control Module) is located behind the POWER STEERING RESERVOIR. Also at the coil pack use any wire witha BROWN STRIPE.