Dodge  Viper SRT/10 2006-2010
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   RED (+)   @ IGNITION SWITCH, PIN 5
 STARTER  YELLOW/ORANGE to PINK/ORANGE (+)  @ STARTER Switch, Pin 3 or BCM, (BLACK/WHITE PLUG(C3) Pin 27, Note #1
 STARTER 2  N/A  
 IGNITION 1  RED/ORANGE (+)  @ IGNITION SWITCH, PIN 3
 IGNITION 2  N/A  
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  BROWN/PURPLE (-) thru a Resistor  @ IGNITION SWITCH, PIN 2 or BCM, (BLACK/GRAY PLUG(C2) Pin 20, Note #1
 ACCESSORY/HEATER BLOWER 2  N/A  
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  WHITE/BLACK (-)  @ HEADLIGHT Switch or BCM, (BLACK/GRAY PLUG(C2) Pin 21, Note #1
 PARKING LIGHTS ( + )  WHITE/YELLOW (+)  @ BCM, (BLACK/GREEN PLUG(C4) Pin 33, Note #1
 POWER LOCK  LT. GREEN/YELLOW (-) thru a 1.5K Ohm Resistor  @BCM, (BLACK/WHITE PLUG(C3) Pin 21, Note #1
 POWER UNLOCK  Use LOCK wire, (-) thru a 249 Ohm Resistor  
 DOOR TRIGGER  PURPLE (-)  @ BCM, (BLACK/WHITE PLUG(C3) Pin 6, Note #1
 DOMELIGHT SUPERVISION  BLACK/BROWN (+)  @ BCM, (BLACK/GRAY PLUG(C2) Pin 12, Note #1
 TRUNK RELEASE  PURPLE/TAN (-)  @ BCM, (BLACK/WHIE PLUG(C3) Pin 18, Note #1
 SLIDING POWER DOOR  N/A  
 HORN  DK. GREEN/WHITE (-)  @ BCM, (BLACK/GREEN PLUG(C4) Pin 17, Note #1
 TACH  Any wire NOT PINK/DK. BLUE or PINK/BROWN (AC)  @ Any FUEL-INJECTOR
 WAIT TO START LIGHT  N/A  
 BRAKE  WHITE/TAN (+)  @ BRAKE SWITCH, PIN 2
 FACTORY ALARM DISARM   PURPLE/ LT. BLUE (-) thru a 1.97K Ohm Resistor  @ BCM, (BLACK/white PLUG(C3) Pin 14, Note #1
 ANTI-THEFT  TRANSPONDER  REQUIRES INTERFACE MODULE SEE NOTE #2 BELOW
 EXTRA INFORMATION
 Note #1: the BCM, (Body Control Module) is located in the Drivers Kick Panel Note #2: Ignition system is MUX wire type with a transponder , requires interface module use PKUMUX, PKUCH2GX, or PKUCG2X.