Dodge  Viper SRT/10 2005-
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   RED (+)   @ IGNITION SWITCH HARNESS
 STARTER  YELLOW/ORANGE (+) or PINK/ORANGE (+)  @ STARTER SWITCH or BCM, Connector C3, Pin 27, See NOTE #1
 STARTER 2  N/A  
 IGNITION 1  RED/ORANGE (+)  @ IGNITION SWITCH HARNESS
 IGNITION 2  N/A  
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  N/A  
 ACCESSORY/HEATER BLOWER 2  N/A  
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  WHITE/BLACK (-)  @ BCM, Connector C4, Pin 21, See NOTE #1
 PARKING LIGHTS ( + )  WHITE/YELLOW (+)  @ BCM, Connector C2, Pin 33, See NOTE #1
 POWER LOCK  LIGHT GREEN/YELLOW (1-Wire System), See NOTE #2  @ BCM, Connector C3, Pin 21, See NOTE #1
 POWER UNLOCK  Same wire, See DIAGRAM  See DIAGRAMS
 DOOR TRIGGER  PURPLE (-) and PURPLE/WHITE (-) Use both, See NOTE #3  @ BCM, Connector C3, Pins 6 and 16, See NOTE #1
 DOMELIGHT SUPERVISION  BLACK/BROWN (+)  @ BCM, Connector C4, Pin 12, See NOTE #1
 TRUNK RELEASE  WHITE/TAN to WHITE (+)  @ BCM, Connector C2, Pin 32, See NOTE #1
 SLIDING POWER DOOR  N/A  
 HORN  DARK GREEN/WHITE (-)  @ BCM, Connector C2, Pin 17, See NOTE #1
 TACH  Any wire NOT BROWN/WHITE (AC)  @ Any IGNITION COIL
 WAIT TO START LIGHT  N/A  
 BRAKE  WHITE/TAN (+)  @ SWITCH ABOVE BRAKE PEDAL
 FACTORY ALARM DISARM   PURPLE/LIGHT BLUE (-) See NOTE *4  @ BCM, Connector C3, Pin 14, See NOTE #1
 ANTI-THEFT  N/A  
 EXTRA INFORMATION
 NOTE #1: the BCM (Body Control Module) is located in the DRIVERS KICK PANEL. NOTE #2: this vehicle uses a 1-Wire Door Locking System, a (-)Negative thru a 1500 Ohm Resistor will LOCK and a (-)Negative thru a 250 Ohm Resistor will UNLOCK, some units will also require 2 extra relays part #775, to connect, See DIAGRAM NOTE #3: when connecting to an ALARM SYSTEM use both DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM NOTE #4: this vehicle Disarms with a (-) Negative thru a 2210 Ohm resistor and an extra relay part #775, to connect. See DIAGRAM