PART | COLOR | LOCATION |
12 VOLT CONSTANT | RED (+) | @ IGNITION SWITCH HARNESS |
STARTER | YELLOW/RED (+) or YELLOW/BLACK (+) | @ IGNITION SWITCH HARNESS |
STARTER 2 | N/A | |
IGNITION 1 | DARK BLUE (+) | @ IGNITION SWITCH HARNESS |
IGNITION 2 | N/A | |
IGNITION 3 | N/A | |
ACCESSORY/HEATER BLOWER 1 | N/A | |
ACCESSORY/HEATER BLOWER 2 | N/A | |
KEYSENSE | N/A | |
PARKING LIGHTS ( - ) | WHITE (-) | @ BCM, Connector C5, Pin 18, See NOTE #1 |
PARKING LIGHTS ( + ) | DO NOT USE! | |
POWER LOCK | WHITE/DARK GREEN (1-Wire System) See NOTE *2 | @ BCM, Connector C3, Pin 21, See NOTE #1 |
POWER UNLOCK | Same wire, See DIAGRAM | See DIAGRAMS |
DOOR TRIGGER | See NOTE #3 | @ BCM Connector C3, Pins 6 and 7, See NOTE #1 |
DOMELIGHT SUPERVISION | TURNS ON with Disarm wire | |
TRUNK RELEASE | LIGHT GREEN/BLACK (+), (Requires Part #775 Relay) | @ BCM, Connector C2, Pin 32, See NOTE #1 |
SLIDING POWER DOOR | N/A | |
HORN | BLACK/RED (-) | @ BCM, Connector C2, Pin 17, See NOTE #1 |
TACH | ANY wire NOT BROWN/WHITE (AC) | @ either COIL PACK |
WAIT TO START LIGHT | N/A | |
BRAKE | WHITE/TAN (+) | @ SWITCH ABOVE BRAKE PEDAL |
FACTORY ALARM DISARM | PURPLE/LIGHT BLUE (-) See NOTE *4 | @ BCM, Connector B3, Pin 14, See NOTE *1 |
ANTI-THEFT | N/A |
EXTRA INFORMATION |
NOTE #1: the BCM (Body Control Module) is located in the DRIVERS KICK PANEL NOTE #2: this vehicle uses a 1-Wire Door Locking System, a (-)Negative thru a 1500 Ohm Resistor will LOCK and a (-)Negative thru a 250 Ohm Resistor will UNLOCK, some units will also require 2 extra relays part #775, to connect, See DIAGRAM NOTE #3: the Drivers door trigger is a TAN (-) Pin 6 and the passenger door trigger is a TAN/RED (-) Pin 7. When connecting to an ALARM SYSTEM, use both DOOR TRIGGER wires and DIODE ISOLATE. to connect, See DIAGRAM NOTE #4: this vehicle Disarms with a (-) Negative thru a 2210 Ohm resistor and an extra relay part #775, to connect. See DIAGRAM |