Dodge  Sprinter 2008-2009
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   RED (+)   @ FUSE BOX, Rear, (BLACK, 3-PIN PLUG) PIN 1
 STARTER  PURPLE (+) NOT for REMOTE START!!  @ FUSE BOX, Rear, (BLACK, 18-PIN PLUG) PIN 1
 STARTER 2  CAN-BUS  
 IGNITION 1  BLACK (+)  @ IGNITION SWITCH (BLACK, 5-PIN PLUG) PIN 2
 IGNITION 2  N/A  
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  CAN-BUS  
 ACCESSORY/HEATER BLOWER 2  N/A  
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  N/A  
 PARKING LIGHTS ( + )  GRAY/BLACK (+) (Left) and GRAY/RED (+) (Right)  @ BCM, (20-PIN PLUG(C3) Pins 1 and 12, Note #2
 POWER LOCK  Use Motor Wires,(Reverse Polarity, 5-wire) See Note #3  
 POWER UNLOCK  Use Motor Wires,(Reverse Polarity, 5-wire) See Note #3  
 DOOR TRIGGER  DK. BLUE/DK. GREEN (-)  @ DDM, (BLACK, 20-PIN PLUG) PIN 8, Note #4
 DOMELIGHT SUPERVISION  BROWN/DK. GREEN (-)  @ BCM, (18-PIN PLUG(C6) Pins 1, Note #2
 TRUNK RELEASE  N/A  
 SLIDING POWER DOOR  YELLOW/DK. GREEN (-)  @ LEFT B Pillar, Sliding door Switch
 HORN  DK. GREEN (+)  @ FUSE BOX, (REAR BLACK, 18-PIN PLUG) PIN 16
 TACH  Any wire NOT BLACK/WHITE or BLACK/GRAY (AC), Note #5  @ Any FUEL-INJECTOR
 WAIT TO START LIGHT  NO INFO @ THIS TIME!  
 BRAKE  NO INFO @ THIS TIME!  
 FACTORY ALARM DISARM   DISARMS with FACTORY REMOTE ONLY!!  
 ANTI-THEFT  CHRYSLERS TRANSPONDER SYSTEM, See Note #1  
 EXTRA INFORMATION
 Note #1: CHRYSLERS TRANSPONDER SYSTEM, Requires Bypass Module: For REMOTE START Only, Part # 791 and an extra ignition key for operation, Note #2: the BCM (Body Control Module) is part of the FUSE/RELAY BOX located in the Drivers Kick Panel. Note #3: the DRIVERS DOOR Motor wires are DK. BLUE/RED - DK. BLUE/BLACK (Reverse Polarity) @ DDM (BLACK, 20-PIN PLUG) PINS 12 and 11. the PASSENGER DOOR Motor wires are DK. BLUE/RED - DK. BLUE/BLACK (Reverse Polarity) @ BCM (52-PIN PLUG(C9) PINS 49 and 48. the SIDE and REAR Door Motor wires are DK. BLUE/BROWN - DK. BLUE/BLACK (Reverse Polarity) @ the BCM, (12-PIN PLUG(C7) Pins 12 and 11. Note #4: the DDM (Driver Door Module)is located in the Drivers Door. Note #5: on DIESEL Models, the TACH wire is a YELLOW/GRAY @ the ECM (BLACK, 94-PIN PLUG) PIN 33. The ECM (Engine Control Module) is located on the Fender behind the Battery.