| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | RED (+) | @ IGNITION SWITCH HARNESS |
| STARTER | BLACK/YELLOW (+) | @ IGNITION SWITCH HARNESS |
| STARTER 2 | N/A | |
| IGNITION 1 | BLACK (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 2 | BLACK/RED (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 3 | N/A | |
| ACCESSORY/HEATER BLOWER 1 | GRAY/DARK GREEN (+) | @ IGNITION SWITCH HARNESS |
| ACCESSORY/HEATER BLOWER 2 | N/A | |
| KEYSENSE | N/A | |
| PARKING LIGHTS ( - ) | N/A | |
| PARKING LIGHTS ( + ) | GRAY/BLACK (+) and GRAY/RED (+) Use both, See NOTE #2 | @ FUSEBOX, BLACK 15 Pin plug, Pins 4 and 6 |
| POWER LOCK | WHITE/YELLOW (TYPE B), See NOTE #3 | @ SWITCH on DASH or CTM, PINK Plug, Pin 7, See NOTE #4 |
| POWER UNLOCK | WHITE/YELLOW (TYPE B), See NOTE #3 | @ SWITCH on DASH or CTM, PINK Plug Pin 7, See NOTE #4 |
| DOOR TRIGGER | BROWN/WHITE (-) | IN DRIVERS DOOR HARNESS |
| DOMELIGHT SUPERVISION | USE DOOR TRIGGER, (Requires Part #775 Relay) | |
| TRUNK RELEASE | N/A | |
| SLIDING POWER DOOR | N/A | |
| HORN | BLACK/YELLOW (-) | @ STEERING COLUMN HARNESS |
| TACH | DARK GREEN/YELLOW (AC) | @ DATA LINK CONNECTOR, Pin 3, See NOTE #5 |
| WAIT TO START LIGHT | N/A | |
| BRAKE | BLACK/RED (+) | @ SWITCH ABOVE BRAKE PEDAL, See NOTE #6 |
| FACTORY ALARM DISARM | BLACK (-) | IN DRIVERS KICK PANEL |
| ANTI-THEFT | CHRYSLER'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 | @ IGNITION SWITCH TUMBLER |
| EXTRA INFORMATION |
| NOTE #1: This vehicle may be equipped with CHRYSLER'S ANTI-THEFT TRANSPONDER System (GRAY IGNITION KEY), if so to remote start will require the 791 BYPASS MODULE and an extra Ignition key, to order go to the SECURITY BYPASS MODULE PAGE on this website. NOTE #2: the PARKING LIGHTS are a 2-Wire System and will require 2 extra Relays part #775, to connect, See DIAGRAM NOTE #3: a (-)Negative pulse on this wire will alternate between LOCK and UNLOCK. Use DIODES on the LOCK and UNLOCK outputs from the unit if the unit you are using does not have on board Door Lock Relays and wire in as a TYPE B tie both wires to this wire in the vehicle. NOTE #4: the CTM (Central Timmer Module) is located under the drivers seat. NOTE #5: the DATA LINK Connector is under the DRIVERS SIDE of DASH. NOTE #6: the BRAKE LIGHT will only test with ignition on. |