Dodge  Ram 2011-
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   RED (+)   @ BATTERY or TIP MODULE, See NOTE #2
 STARTER  YELLOW/GRAY (+) (for STARTER IMMOBLIZER Only!!)  BLUE 26-PIN PLUG, PIN 8 @ TIP MODULE, See NOTE #2
 STARTER 2  N/A  
 IGNITION 1  PINK/WHITE or PINK/TAN (+)  BLACK 12-PIN PLUG, PIN 3 @ IGNITION SWITCH
 IGNITION 2  N/A  
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  DK. BLUE/PINK (+) (for ACCESSORY Sense Only)  GRAY 3-PIN PLUG, PIN 1 @ CIGARETTE LIGHTER
 ACCESSORY/HEATER BLOWER 2  N/A  
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  WHITE (-) THRU A 1000 OHM Resistor  BLACK 10-PIN PLUG, PIN 1 @ HEADLIGHT SWITCH
 PARKING LIGHTS ( + )  WHITE/LT. GREEN(+)(LEFT) and WHITE/TAN(+)(RIGHT), Use both and Isolate with Relays!  BROWN 40-PIN PLUG, PIN 19 and BLACK/RED 50-PIN PLUG, PIN 6 @ TIP MODULE, See NOTE #2
 POWER LOCK  PURPLE/LT. GREEN (TYPE B) THRU A 330 Ohm Resistor, See NOTE #4  GREEN 10-PIN PLUG, PIN 8 @ PASSENGER DOOR LOCK SWITCH
 POWER UNLOCK  Same wire, (TYPE B) THRU A 100 Ohm Resistor, See NOTE #4  DIAGRAM
 DOOR TRIGGER  PURPLE (-)  in DRIVERS KICK @ DOOR HARNESS
 DOMELIGHT SUPERVISION  YELLOW/WHITE (+)  in DRIVERS
 TRUNK RELEASE  N/A  
 SLIDING POWER DOOR  N/A  
 HORN  DK. GREEN/PURPLE (-)  WHITE 6-PIN PLUG, PIN 3 @ HORN SWITCH
 TACH  Any wire NOT BROWN/WHITE (AC), See NOTE #3  @ Any FUEL-INJECTOR
 WAIT TO START LIGHT  N/A  
 BRAKE  WHITE (+)  @ BRAKE PEDAL SWITCH
 FACTORY ALARM DISARM   N/A  
 ANTI-THEFT  DODGE'S MULTIPLEX IGNITION/TRANSPONDER SYSTEM, See NOTE #1  
 EXTRA INFORMATION
 NOTE #1: This vehicle is equipped with DODGE'S MULTIPLEX IGNITION/TRANSPONDER SYSTEM and requires a INTERFACE BYPASS MODULE for REMOTE STARTING and KEYLESS ENTRY. Part # DB-ALL or XK09 INTERFACE BYPASS MODULE, either module will work for this application. to oder go to the INTERFACE BYPASS MODULE Page on this website. NOTE #2: The TIP Module is located in the DRIVERS FRONT Corner of the Engine compartment NOTE #3: TACH wire for DIESELS use DK. BLUE/GRAY @ PCM, located on the lower Driver Front of the engine NOTE #4: You can use RESISTORS for the door locks on this vehicle without using an INTERFACE MODULE, to do this go to the 2009-2010 DODGE JOURNEY Door Lock diagram, buts use the wire colors and location as listed on this page for the 2011 RAM TRUCK.