| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | PINK/BLACK (+) and RED (+) | @ IGNITION SWITCH HARNESS |
| STARTER | YELLOW (+) | @ IGNITION SWITCH HARNESS |
| STARTER 2 | N/A | |
| IGNITION 1 | BLUE (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 2 | RED/WHITE (+) ( with Auto Stick only) | @ IGNITION SWITCH HARNESS |
| IGNITION 3 | N/A | |
| ACCESSORY/HEATER BLOWER 1 | BLACK/ORANGE (+) | @ IGNITION SWITCH HARNESS |
| ACCESSORY/HEATER BLOWER 2 | BLACK/WHITE (+) | @ IGNITION SWITCH HARNESS |
| KEYSENSE | LT. BLUE (-) | FROM IGNITION SWITCH |
| PARKING LIGHTS ( - ) | N/A | |
| PARKING LIGHTS ( + ) | BLACK/YELLOW (+) | @ HEADLIGHT SWITCH |
| POWER LOCK | LIGHT GREEN (1-Wire Door Lock System), See NOTE #2 | IN DRIVERS DOOR HARNESS, See DIAGRAM |
| POWER UNLOCK | Same wire, See DIAGRAM | See DIAGRAMS |
| DOOR TRIGGER | TAN/BLACK (-) and LIGHT BLUE/ORANGE (-) Use both, See NOTE #3 | IN DRIVERS KICK PANEL, HARNESS to REAR of vehicle or at KEYLESS ENTRY MODULE, See NOTE *3 |
| DOMELIGHT SUPERVISION | YELLOW (-), (Requires #775 Relay) | IN DRIVERS KICK PANEL |
| TRUNK RELEASE | BROWN/LIGHT BLUE (-) | @ TRUNK RELEASE SWITCH |
| SLIDING POWER DOOR | N/A | |
| HORN | BLACK/RED (-) | @ HORN SWITCH or at KEYLESS MODULE, See NOTE #4 |
| TACH | ANY wire NOT DARK GREEN/ORANGE (AC) | @ COIL PACK or FUEL INJECTOR |
| WAIT TO START LIGHT | N/A | |
| BRAKE | WHITE/TAN (+) | @ SWITCH ABOVE BRAKE PEDAL |
| FACTORY ALARM DISARM | N/A | |
| ANTI-THEFT | CHRYSLER'S ANTI-THEFT TRANSPONDER System (GRAY IGNITION KEY), See NOTE #1 | @ IGNITION SWITCH TUMBLER |
| EXTRA INFORMATION |
| NOTE #1: This vehicle may be equipped with CHRYSLER'S ANTI-THEFT TRANSPONDER System (GRAY IGNITION KEY), if so to remote start will require the 791 BYPASS MODULE and an extra Ignition key, to order go to the SECURITY BYPASS MODULE PAGE on this website. NOTE #2: this vehicle uses a 1-Wire Door Locking system, if vehicle is WITHOUT a FACTORY ALARM SYSTEM, LOCK requires a (-)Negative thru a 1000 Ohm Resistor and UNLOCK is a (-)Negative thru a 250 Ohm Resistor. If vehicle HAS a FACTORY ALARM SYSTEM, ARM/LOCK is a (-)Negative thru a 2700 Ohm Resistor and DISARM/UNLOCK is a (-)Negative thru a 7500 Ohm Resistor, some units will require 2 extra relays part #775, to connect, See DIAGRAM. NOTE #3: the DRIVERS DOOR is a TAN/BLACK (-) and the PASSENGER DOOR is a LIGHT BLUE/ORANGE (-) when connecting to an ALARM SYSTEM, use both DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM NOTE #4: the KEYLESS ENTRY MODULE is located in the Center of the Dash, remove top of dash to access. |