NOTE #1: This vehicle is equipped with CHRYSLER'S ANTI-THEFT TRANSPONDER System
to remote start will require the 791 BYPASS MODULE and an extra Ignition key,
CHRYSLER'S TRANSPONDER SYSTEM is Standard on the LIMITED and SLT V8 Models
and Optional on the Adventurer and on the SLT V6 Models.
to order go to the SECURITY BYPASS MODULE PAGE on this website.
NOTE #2: the PURPLE (-) Accessory wire must be powered up using an extra Relay Part 775,
See DIAGRAM
NOTE #3: the (-) Negative Parking Lights on this Vehicle require a (-) Negative or Ground thru
a 1100 Ohm Resistor a Relay Part #775 must be used, to Connect See DIAGRAM.
NOTE #4: the (+) Positive Parking Lights on this vehicle require adding (2) Extra Relays Part
#775 to turn ON both the Left and the Right Parking Light circuits in this vehicle,
See DIAGRAM
NOTE #5: this vehicle uses a 1-Wire Door Locking System, a (-) Negative thru a 330 Ohm
Resistor will LOCK and (-) Negative thru a 100 Ohm Resistor will UNLOCK, if your
unit DOES NOT have On-Board Door Lock Relays, (2) Extra Relays Part #775 will
be required, See DIAGRAM.
On vehicles without memory Seats, the Lock/Unlock wire can be found in the Drivers
Kick Panel at the Door Harness. With Memory Seats, this wire is located in the Drivers
Door at the Drivers Door Memory Mirror Module.
NOTE #6: DRIVERS Front door is a PURPLE (-). The PASSANGER Front Door is a PURPLE/WHITE
(-). The DRIVERS REAR Door is a PURPLE/GRAY (-) and the PASSANGER REAR Door
is a PERPLE/YELLOW (-). Tje REAR DOOR Trigger wires are located in a LARGE
74-Pin Plug near the FUSEBOX. For the FRONT DOOR Trigger wires: On vehicles
without memory Seats, the FRONT DOOR Trigger wires are located in the same 74-pin
plug as the REAR DOOR Triggers. With Memory Seats, the DRIVERS DOOR Trigger
wire is located in the Drivers Door at the Drivers Door Memory Mirror Module. the
PASSENGER DOOR Trigger wire is located in the PASSANGER DOOR at the PASSENGER
MEMORY MIRROR MODULE. When connecting to an Alarm system use all 4 wires and
DIODE ISOLATE, See DIAGRAM
|