NOTE #1: This vehicle Requires a Special INTERFACE BYPASS MODULE due to its MULTIPLEXED
IGNITION/ANTI-THEFT SYSTEM, it will Require Part # DB-ALL, Module will Interface
with the IGNITION/ANTI-THEFT System, KEYLESS ENTRY and TRUNK Release
with nothing else needed, to order go to the INTERFACE BYPASS MODULE Page on this
website........SPECIAL NOTE....You can use the 791 and an extra Ignition key BUT you
MUST build the RELAY and RESISTOR circuit as shown to remote start!!
NOTE #2: To turn on the PARKING LIGHTS requires a (-)Negative thru a 2000 Ohm resistor and
an extra relay part #775 to connect, See DIAGRAM
NOTE #3: This vehicle uses a 1-Wire Door Locking System requiring a (-)Negative thru a 5200
Ohm Resistor for LOCK, and a (-)Negative thru a 2000 Ohm Resistor for UNLOCK,
some units will also require 2 extra relays part #775 to connect, See DIAGRAMS
Also SEE NOTE #1
NOTE #4: This vehicle uses 4 door pin trigger wires, the DRIVERS DOOR is a PURPLE (-) at PIN
6, the PASSENGERS DOOR is a PURPLE/WHITE (-) PIN 7, the DRIVERS SIDE SLIDING
DOOR is a PURPLE/GRAY, PIN 8 and the PASSENGER SIDE SLIDING DOOR is a
PURPLE/YELLOW, PIN 5. When connecting to an ALARM SYSTEM use all 4 wires and
DIODE ISOLATE. See DIAGRAM
NOTE #5: The BCM (Body Control Module is located in the DRIVERS KICK PANEL, near the
PARKING BRAKE. The BCM has 5 Plugs, (1) 6-Pin Plug, and (4) 34-Pin PLugs.
NOTE #6: The Rear Hatch Pop is a (-) Negative thru a 1500 Ohm Resistor and requires an
extra relay part #775 to connect, See DIAGRAM
NOTE #7: The SLIDING DOORS require a (-)Negative thru a 1500 Ohm Resistor for the
DRIVERS SIDE and a (-)Negative thru a 2700 Ohm Resistor for the PASSANGER SIDE
and 2 extra relays part #775 for each door, See DIAGRAM.
NOTE #8: The TACH wire on the 2.4L is BLUE/GREEN or BLUE/TAN. On the 3.3L and 3.8L use
the BLUE/GREEN, BLUE/TAN or BLUE/ORANGE
|