NOTE #1: This vehicle may be equipped with CHRYSLER'S ANTI-THEFT TRANSPONDER System
(GRAY IGNITION KEY), if so to remote start will require the 791 BYPASS MODULE and
an extra Ignition key, to order go to the SECURITY BYPASS MODULE PAGE on this
website.
NOTE #2: To Remote Start this vehicle and turn on the AC/Heater, will require an extra relay
part #775 and a (-)Negative thru a 180 Ohm Resistor, THIS MUST BE INSTALLED to
operate in Remote Start mode, to connect, See DIAGRAM.
NOTE #3: To turn on the PARKING LIGHTS requires a (-)Negative thru a 2000 Ohm resistor and
an extra relay part #775 to connect, See DIAGRAM
NOTE #4: This vehicle uses a 1-Wire Door Locking System requiring a (-)Negative thru a 5200
Ohm Resistor for LOCK, and a (-)Negative thru a 2000 Ohm Resistor for UNLOCK,
some units will also require 2 extra relays part #775 to connect, See DIAGRAMS
NOTE #5: This vehicle uses 4 door pin trigger wires, the DRIVERS DOOR is a PURPLE (-) at PIN
6, the PASSENGERS DOOR is a PURPLE/WHITE (-) PIN 7, the DRIVERS SIDE SLIDING
DOOR is a PURPLE/GREY, PIN 8 and the PASSENGER SIDE SLIDING DOOR is a
PURPLE/YELLOW, PIN 5. When connecting to an ALARM SYSTEM use all 4 wires and
DIODE ISOLATE. See DIAGRAM
NOTE #6: The BCM (Body Control Module is located in the DRIVERS KICK PANEL, near the
PARKING BRAKE. The BCM has 5 Plugs, (1) 6-Pin Plug, and (4) 34-Pin PLugs.
NOTE #7: The Rear Hatch Pop is a (-) Negative thru a 1500 Ohm Resistor and requires an
extra relay part #775 to connect, See DIAGRAM
NOTE #8: The SLIDING DOORS require a (-)Negative thru a 1500 Ohm Resistor for the DRIVERS
SIDE and a (-)Negative thru a 2700 Ohm Resistor for the PASSANGER SIDE and 2
extra relays part #775 for each door, See DIAGRAM.
NOTE #9: The TACH wire on the 2.4L is BLUE/GREEN or BLUE/TAN. On the 3.3L and 3.8L use the
BLUE/GREEN, BLUE/TAN or BLUE/ORANGE. (AC)
NOTE #10: This vehicle will DISARM with (-)Negative thru a 9000 Ohm resistor, MUST use SINGLE
pulse to DISARM and a DOUBLE pluse on this wire will also UNLOCK.
|