| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | RED (+) | @ IGNITION SWITCH HARNESS |
| STARTER | YELLOW (+) | @ IGNITION SWITCH HARNESS |
| STARTER 2 | N/A | |
| IGNITION 1 | DARK BLUE (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 2 | N/A | |
| IGNITION 3 | N/A | |
| ACCESSORY/HEATER BLOWER 1 | BLACK/ORANGE (+) | @ IGNITION SWITCH HARNESS |
| ACCESSORY/HEATER BLOWER 2 | BLACK/WHITE (+) | @ IGNITION SWITCH HARNESS |
| KEYSENSE | N/A | |
| PARKING LIGHTS ( - ) | GREEN/WHITE (-) or GREEN/RED (-), See NOTE #2 | @ HEADLIGHT SWITCH, See DIAGRAM |
| PARKING LIGHTS ( + ) | N/A | |
| POWER LOCK | WHITE/GREEN (1-Wire Door Lock System) See NOTE #3 | @ LEFT PLUG, BOTTOM of BCM/FUSE BOX, See DIAGRAM |
| POWER UNLOCK | Same wire, See DIAGRAM | See DIAGRAM |
| DOOR TRIGGER | BROWN/LIGHT GREEN (-) | @ DOME LIGHT ON/OFF SWITCH |
| DOMELIGHT SUPERVISION | BROWN/WHITE (-), (Requires #775 Relay) | @ DOME LIGHT ON/OFF SWITCH |
| TRUNK RELEASE | N/A | |
| SLIDING POWER DOOR | N/A | |
| HORN | BLACK/RED (-) or GRAY/ORANGE (-) | @ STEERING COLUMN HARNESS |
| TACH | GRAY or GRAY/RED (AC) | @ IGNITION COIL PACK |
| WAIT TO START LIGHT | N/A | |
| BRAKE | WHITE/TAN (+) | @ SWITCH ABOVE BRAKE PEDAL |
| FACTORY ALARM DISARM | TO DISARM/ARM, See NOTE #4 | Uses DOOR LCCK and UNLOCK wires |
| ANTI-THEFT | CHRYSLER'S ANTI-THEFT TRANSPONDER System (GRAY IGNITION KEY), See NOTE #1 | @ IGNITION SWITCH TUMBLER |
| EXTRA INFORMATION |
| NOTE #1: This vehicle may be equipped with CHRYSLER'S ANTI-THEFT TRANSPONDER System (GRAY IGNITION KEY), if so to remote start will require the 791 BYPASS MODULE and an extra Ignition key, to order go to the SECURITY BYPASS MODULE PAGE on this website. NOTE #2: The PARKING LIGHTS on this vehicle are a (-)Negative type and will require an extra Relay part #775, See DIAGRAM. You can find a (+)Positive Parking Light wire at the Marker Lights out under the hood and make the connection there without adding the extra relay. NOTE #3: This vehicle uses a 1-Wire Door Locking System and will require extra parts. To LOCK requires a (-)Negative thru a 1500, Arm requires a (-)Negative thru a 4020 Ohm Resistor and to UNLOCK requires a (-)Negative thru a 250 Ohm Resistor and Disarm requires a (-)Negative thru a 665 Ohm Resistor. Some units will also require 2 extra relays Part #775 to connect, See DIAGRAM. NOTE #4: If vehicle is equipped with a FACTORY SECURITY System, you will need to UNLOCK THE VEHICLE, before Remote Starting to keep the Factory Security from sounding See DIAGRAM |