Chrysler  Sebring Sedan 2008-2010
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   RED (+)   CONNECT DIRECTLY TO BATTERY
 STARTER  SEE NOTE #1  
 STARTER 2  PURPLE/BROWN (+) thru a 180 Ohm Resistor, See NOTE #1  @ IGNITION SWITCH, (BLACK, 5-Pin Plug) Pin 2
 IGNITION 1  PINK (+)  @ IGNITION SWITCH, (BLACK, 5-Pin Plug) Pin 3
 IGNITION 2  N/A  
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  SEE NOTE #1, Use STARTER 2 wire, (-) thru a 610 Ohm Resistor, See NOTE #1  
 ACCESSORY/HEATER BLOWER 2  N/A  
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  N/A  
 PARKING LIGHTS ( + )  WHITE/PURPLE (+)  in DRIVERS KICK PANEL, Harness to Rear of Vehile.
 POWER LOCK  LIGHT GREEN/PURPLE (-) SEE NOTE #2, (-) thru a 330 Ohm Resistor  in DRIVERS KICK PANEL or INSTRUMENT CLUSTER, (BROWN 20-Pin Plug) Pin 18, SEE DIAGRAM
 POWER UNLOCK  SAME AS POWER LOCK, (-) thru a 100 Ohm Resistor  SEE DIAGRAM
 DOOR TRIGGER  PURPLE (-)  in DRIVERS KICK PANEL or INSTRUMENT CLUSTER, (BROWN 20-Pin Plug) Pin 3
 DOMELIGHT SUPERVISION  YELLOW/WHITE (+)  in DRIVERS KICK PANEL or INSTRUMENT CLUSTER, (BROWN 20-Pin Plug) Pin 4
 TRUNK RELEASE  LIGHT GREEN/WHITE (-) (Requires #775 Relay)  @ RELEASE SWITCH or INSTRUMENT CLUSTER, (BLACK, 20-Pin Plug) Pin 13
 SLIDING POWER DOOR  N/A  
 HORN  DARK GREEN/PURPLE (-)  @ HORN SWITCH or INSTRUMENT CLUSTER, (BLACK, 20-Pin Plug) Pin 10
 TACH  @ Any wire NOT BROWN/YELLOW (AC)  @ ANY FUEL INJECTOR
 WAIT TO START LIGHT  N/A  
 BRAKE  DARK GREEN/WHITE (+)  @ BRAKE SWICH or INSTRUMENT CLUSTER, (BROWN 20-Pin Plug) Pin 8
 FACTORY ALARM DISARM   DISARMS WITH FACTORY REMOTE ONLY!!  
 ANTI-THEFT  CHRYSLER'S MUTLIPLEX IGNITION/ANTI-THEFT SYSTEM, See NOTE #1  
 EXTRA INFORMATION
 Note #1: CHRYSLER'S MUX/TRANSPONDER IGNITION , Requires INTERFACE BYPASS MODULE Part # DB-ALL or XK09 that will BYPASS the ANTI-THEFT SYSTEM and BYPASS the need for the above resistors and relays, it will also bypass the need for the resistors on the DOOR LOCKS, to order please go to the INTERFACE BYPASS MODULE page on this website NOTE #2: THIS VEHICLE USES A SINGLE WIRE DOOR LOCKING SYSTEM THAT REQUIRES A 100 OHM AND 330 OHM RESISTORS WHEN NOT USING INTERFACE MODULE. SEE DIAGRAM. SEE NOTE #1 ALSO!!