| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | PINK/BLACK (+) and RED (+) | @ IGNITION SWITCH HARNESS |
| STARTER | YELLOW (+) | @ IGNITION SWITCH HARNESS |
| STARTER 2 | N/A | |
| IGNITION 1 | BLUE (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 2 | GREEN/RED (+) 20 Gauge wire | @ IGNITION SWITCH HARNESS |
| IGNITION 3 | N/A | |
| ACCESSORY/HEATER BLOWER 1 | BLACK/ORANGE (+) | @ IGNITION SWITCH HARNESS |
| ACCESSORY/HEATER BLOWER 2 | BLACK/WHITE (+) | @ IGNITION SWITCH HARNESS |
| KEYSENSE | N/A | |
| PARKING LIGHTS ( - ) | N/A | |
| PARKING LIGHTS ( + ) | BLACK/YELLOW (+) | IN DRIVERS KICK PANEL or HEADLIGHT SWITCH |
| POWER LOCK | WHITE/GREEN (1-Wire Door Lock System), See NOTE #2 | @ BCM, C4, Pin 15, See NOTE #3 |
| POWER UNLOCK | Same wire, See DIAGRAM | See DIAGRAM |
| DOOR TRIGGER | See NOTE #5 | @ BCM, See NOTE #3 |
| DOMELIGHT SUPERVISION | TAN (-) | @ BCM, Connector 4, Pin 5, See NOTE #3 |
| TRUNK RELEASE | BLACK/WHITE (5-Wire), See NOTE #6 | @ BCM, Connector 4, Pin 1, See NOTE #3 |
| SLIDING POWER DOOR | N/A | |
| HORN | BLACK/RED (-) | @ STEERING COLUMN HARNESS |
| TACH | ANY wire that is NOT GREEN/LIGHT GREEN (AC) | @ Any COIL or FUEL INJECTOR |
| WAIT TO START LIGHT | N/A | |
| BRAKE | WHITE/TAN (+) | @ SWITCH ABOVE BRAKE PEDAL |
| FACTORY ALARM DISARM | LIGHT GREEN/ORANGE (+), See NOTE #5 | @ BCM, Connector 4, Pin 4, See NOTE #3 |
| ANTI-THEFT | CHRYSLER'S ANTI-THEFT TRANSPONDER System (GRAY IGNITION KEY), See NOTE #1 | @ IGNITION SWITCH TUMBLER |
| EXTRA INFORMATION |
| NOTE #1: This vehicle may be equipped with CHRYSLER'S ANTI-THEFT TRANSPONDER System (GRAY IGNITION KEY), if so to remote start will require the 791 BYPASS MODULE and an extra Ignition key, to order go to the SECURITY BYPASS MODULE PAGE on this website. NOTE #2: This vehicle uses a 1-Wire Door Locking System that requires a (+)Positive thru a 1800 Ohm Resistor to LOCK and a (+)Positive thru a 750 Ohm Resistor to UNLOCK, some units will also require 2 extra relays part #775 to connect, See DIAGRAM NOTE #3: The BCM (Body Control Module) is located under the DRIVERS SIDE of DASH and is attached to the FUSE/RELAY box. Connector 4 is a 26 pin plug at the bottom edge of the BCM. NOTE #4: this vehicle uses 4 door pin triggers, at the BCM Connector 4, the DRIVERS DOOR is a TAN (-) Pin 5, the PASSENGERS DOOR is a TAN/RED (-) Pin 6, the DRIVERS REAR DOOR is a TAN/ORANGE (-) Pin 7 and the PASSENGER REAR DOOR is a TAN/YELLOW, Pin 8. When connecting to an alarm system use all 4 wires and DIODE ISOLATE, See DIAGRAM. NOTE #5; To DISARM requires a (+)Positive thru a 750 Ohm Resistor and an extra Relay part #775, to connect, See DIAGRAM NOTE #6: the TRUNK/HATCH Release on this vehicle is a 5-Wire System and will require an extra Relay Part #775, to connect, See DIAGRAM. |