Chrysler  Sebring Coupe 2003-2007
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   WHITE/RED (+)   @ IGNITION SWITCH HARNESS
 STARTER  BLACK/RED (+)  @ IGNITION SWITCH HARNESS
 STARTER 2  N/A  
 IGNITION 1  DARK GREEN (+)  @ IGNITION SWITCH HARNESS
 IGNITION 2  N/A  
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  BLUE/RED (+)  @ IGNITION SWITCH HARNESS
 ACCESSORY/HEATER BLOWER 2  N/A  
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  N/A  
 PARKING LIGHTS ( + )  PINK/BLACK (+) and GREEN/WHITE (+) Use both, See NOTE #3  IN DRIVERS KICK PANEL, 38-PIN PLUG, PINS 27 and 26
 POWER LOCK  PURPLE (TYPE B)  IN DRIVERS KICK PANEL, BLACK 32-Pin Plug
 POWER UNLOCK  LIGHT GREEN/RED (TYPE B)  IN DRIVERS KICK PANEL, BLACK 32-Pin Plug
 DOOR TRIGGER  GREEN/YELLOW (-)  @ FUSEBOX, BLACK 19-Pin Plug
 DOMELIGHT SUPERVISION  GREEN/ORANGE (-), Requires #775 Relay  @ TOP of FUSEBOX, 3-PIN PLUG
 TRUNK RELEASE  GREEN/WHITE (5-Wire), See NOTE #4  IN DRIVERS KICK PANEL, WHITE 43-Pin Plug
 SLIDING POWER DOOR  N/A  
 HORN  LIGHT GREEN/BLACK (-)  @ STEERING COLUMN HARNESS
 TACH  WHITE or WHITE/RED (AC)  @ TEST CONNECTOR, See NOTE #2
 WAIT TO START LIGHT  N/A  
 BRAKE  GREEN/ORANGE (+)  @ STEERING COLUMN HARNESS
 FACTORY ALARM DISARM   ORANGE (-)  IN DRIVERS KICK PANEL, BLACK 32-Pin Plug
 ANTI-THEFT  CHRYSLER'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1  @ IGNITION SWITCH TUMBLER
 EXTRA INFORMATION
 NOTE #1: This vehicle may be equipped with CHRYSLER'S ANTI-THEFT TRANSPONDER System (GRAY IGNITION KEY), if so to remote start will require the 791 BYPASS MODULE and an extra Ignition key, to order go to the SECURITY BYPASS MODULE PAGE on this website. NOTE #2: The TACH wire is at the TEST CONNECTOR in the FUSEBOX under the hood. It is a "T" SHAPED PLUG. The TACH wire is the terminal on the TOP LEFT of the "T". Under the connector at this terminal you will find a WHITE or WHITE/RED wire. NOTE #3: This vehicle has 2 PARKING LIGHT wires that will require an extra Relay part #775 to connect, See DIAGRAM. NOTE #4: When connecting to the TRUNK RELEASE on this vehicle, a extra relay part #775 will be required, See DIAGRAM