Chrysler  Sebring Convertible 1996-2000
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   PINK/BLACK (+)   @ IGNITION SWITCH HARNESS
 STARTER  YELLOW (+)  @ IGNITION SWITCH HARNESS
 STARTER 2  N/A  
 IGNITION 1  BLUE (+)  @ IGNITION SWITCH HARNESS
 IGNITION 2  BLACK/WHITE (+)  @ IGNITION SWITCH HARNESS
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  BLACK/ORANGE (+)  @ IGNITION SWITCH HARNESS
 ACCESSORY/HEATER BLOWER 2  N/A  
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  N/A  
 PARKING LIGHTS ( + )  BLACK/YELLOW (+)  @ REAR of FUSEBOX
 POWER LOCK  WHITE/GREEN (1-Wire Door Lock System), See NOTE #2  @ BACK of FUSEBOX, See DIAGRAM
 POWER UNLOCK  Same wire, See DIAGRAM  See DIAGRAMS
 DOOR TRIGGER  BROWN/GREEN (-)  @ BOTTOM of FUSEBOX
 DOMELIGHT SUPERVISION  YELLOW (-)  @ RELAY, RIGHT of STEERING COLUMN
 TRUNK RELEASE  LIGHT GREEN/BLACK (+)  @ TRUNK RELEASE SWITCH
 SLIDING POWER DOOR  N/A  
 HORN  BLACK/RED (-)  @ STEERING COLUMN HARNESS
 TACH  BLACK/GRAY (AC)  @ IGNITION COIL PACK
 WAIT TO START LIGHT  N/A  
 BRAKE  WHITE/TAN (+)  @ SWITCH ABOVE BRAKE PEDAL
 FACTORY ALARM DISARM   LIGHT GREEN/ORANGE (+), See NOTE #3, See DIAGRAM  IN DRIVERS KICK PANEL, ABOVE HOOD RELEASE
 ANTI-THEFT  CHRYSLER'S ANTI-THEFT TRANSPONDER System (GRAY IGNITION KEY), See NOTE #1  @ IGNITION SWITCH TUMBLER
 EXTRA INFORMATION
 NOTE #1: This vehicle may be equipped with CHRYSLER'S ANTI-THEFT TRANSPONDER System (GRAY IGNITION KEY), if so to remote start will require the 791 BYPASS MODULE and an extra Ignition key, to order go to the SECURITY BYPASS MODULE PAGE on this website. NOTE #2: This vehicle uses a 1-Wire Door Locking System that requires a (+)Positive to LOCK and a (+)Positive thru a 1500 Ohm Resistor to UNLOCK, some units will also require 2 extra relays part #775, to connect, See DIAGRAM NOTE #3: To DISARM requires a (+)Positive thru a 470 Ohm Resistor and a Relay part #775, to connect, See DIAGRAM