| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | PINK/BLACK (+) and RED (+) | @ IGNITION SWITCH HARNESS |
| STARTER | YELLOW (+) | @ IGNITION SWITCH HARNESS |
| STARTER 2 | N/A | |
| IGNITION 1 | BLUE (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 2 | N/A | |
| IGNITION 3 | N/A | |
| ACCESSORY/HEATER BLOWER 1 | BLACK/ORANGE (+) | @ IGNITION SWITCH HARNESS |
| ACCESSORY/HEATER BLOWER 2 | N/A | |
| KEYSENSE | LIGHT BLUE (-) | @ IGNITION SWITCH HARNESS |
| PARKING LIGHTS ( - ) | N/A | |
| PARKING LIGHTS ( + ) | BLACK/YELLOW (+) | @ HEADLIGHT SWITCH |
| POWER LOCK | WHITE/GREEN (1-Wire Door Lock System), See NOTE #2 | IN DRIVERS KICK PANEL, AT DOOR HARNESS, See DIAGRAM |
| POWER UNLOCK | Same wire, See DIAGRAM | See DIAGRAM |
| DOOR TRIGGER | See NOTE #3 | IN EACH KICK PANEL, See DIAGRAM |
| DOMELIGHT SUPERVISION | TAN (-) or TAN/BLUE (-), (Requires #775 Relay) | IN DRIVERS KICK PANEL |
| TRUNK RELEASE | N/A | |
| SLIDING POWER DOOR | N/A | |
| HORN | BLACK/RED (-) | @ STEERING COLUMN HARNESS |
| TACH | BLACK/GRAY (AC) | @ IGNITION COIL |
| WAIT TO START LIGHT | N/A | |
| BRAKE | WHITE/TAN (+) | @ SWITCH ABOVE BRAKE PEDAL |
| FACTORY ALARM DISARM | DISARMS WITH UNLOCK | |
| ANTI-THEFT | CHRYSLER'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 | @ IGNITION SWITCH TUMBLER |
| EXTRA INFORMATION |
| NOTE #1: This vehicle may be equipped with CHRYSLER'S ANTI-THEFT TRANSPONDER System (GRAY IGNITION KEY), if so to remote start will require the 791 BYPASS MODULE and an extra Ignition key, to order go to the SECURITY BYPASS MODULE PAGE on this website. NOTE #2: This vehicle uses a 1-Wire Door Locking System, LOCK requires a (-)Negative thru a 3000 Ohm Resistor and UNLOCK, requires a (-)Negative thru a 7200 Ohm Resistor, and requires a DOUBLE PULSE to UNLOCK. Some unit also require 2 extra relays Part #775, to connect, See DIAGRAM. You can also get a INTERFACE BYPASS MODULE the Part #XK09 that will do this for you without adding extra relays and resistors, these Modules will also do dome light supervision and trunk pop with nothing needed, to order please go to the INTERFACE BYPASS MODULE Page on this website NOTE #3: This vehicle has 2 Door Trigger wires a TAN (-) or TAN/BLUE (-) in the DRIVERS KICK PANEL for the DRIVERS DOOR and a BLUE/ORANGE (-) in the PASSENGERS KICK PANEL is for all other doors. When using an ALARM SYSTEM use both wires and DIODE ISOLATE. See DIAGRAM |