| NOTE #1: this vehicle requires a Special Circuit to Crank the vehicle and turn on the Accessories
that requires (2) Relays and (2) Resistors, Starter #2 requires a (-)Negative thru a
180 Ohm Resistor and Accessory requires a (-)Negative thru a 610 Ohm Resistor to
connect this circuit up See DIAGRAM...........SPECIAL NOTE.................you can now
get a INTERFACE BYPASS MODULE Part # DB-ALL or XK09 that will BYPASS the ANTI
-THEFT SYSTEM and BYPASS the need for the above resistors and relays, it will also
bypass the need for the resistors on the door locks,
to order please go to the INTERFACE BYPASS MODULE page on this website.
NOTE #2: This vehicle uses a 1-Wire Door Locking System, a (-)Negative thru a 330 Ohm
Resistor LOCKS and a (-)Negative thru a 100 Ohm Resistor UNLOCKS. 2 Extra
Relays may be required, See DIAGRAM. There is a INTERFACE BYPASS available that
will let you do the DOOR LOCKS without adding the RELAYS and RESISTORS
See NOTE #1
NOTE #3: This vehicle uses 4 door triggers, the DRIVERS DOOR is a PURPLE (-) in a WHITE
Plug, Pin 3, the PASSENGERS DOOR is a PURPLE/WHITE (-) in a WHITE Plug, Pin 3,
the DRIVERS SIDE REAR DOOR is a PURPLE/GRAY (-) in a GRAY 26 Pin plug, Pin 10
and the PASSENGERS SIDE REAR DOOR is a PURPLE/YELLOW (-) in a GRAY 26 Pin
Plug, Pin 9, when connecting to an ALARM SYSTEM use all 4 wires and DIODE
ISOLATE. These wire are located in each kick panel or behind the instrument cluster.
See DIAGRAM
NOTE #4: to turn on the parking Lights on this vehicle will require a (-) Negative thru a 1670
Ohm and may also require a #775 Relay, to connect See DIAGRAM
|