Chrysler 200 2011-2012 Printer Friendly Wiring Chart

Chrysler 200 2011-2012

PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+) (40AMP)	ABOVE DRIVERS KICK, in a GREEN 43-PIN PLUG, PIN 4 or 5
STARTER	See NOTE #1
STARTER 2	N/A
IGNITION 1	PINK (+)	@ IGNITION SWITCH, BLACK 5-PIN PLUG, PIN 3
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	See NOTE #1
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	WHITE/PURPLE (+)	ABOVE DRIVERS KICK, in a GREEN 43-PIN PLUG, PIN 42
POWER LOCK	LT.GREEN/PURPLE (-) THRU a 330 Ohm Resistor LOCKS	UNDER DRIVERS DASH, LT.GRAY 43-PIN PLUG, PIN 28
POWER UNLOCK	Use LOCK wire, (-) THRU a 100 Ohm Resitor UNLOCKS
DOOR TRIGGER	PURPLE (-)	UNDER DRIVERS DASH, LT.GRAY 43-PIN PLUG, PIN 14
DOMELIGHT SUPERVISION	YELLOW/WHITE (+)	UNDER DRIVERS DASH, LT.GRAY 43-PIN PLUG, PIN 7
TRUNK RELEASE	LT. GREEN/WHITE (-)	@ TRUNK RELEASE SWITCH, BLACK 2-PI PLUG, PIN 2
SLIDING POWER DOOR	N/A
HORN
TACH	BROWN/YELLOW, BROWN/DK. BLUE, BROWN/LT. BLUE, BROWN/TAN, BROWN/ORANGE or BROWN/PURPLE (AC)	@ Any FUEL-INJECTOR, BLACK 2-PIN PLUG, PIN1,(I4), PIN 2(V6)
WAIT TO START LIGHT	N/A
BRAKE	DK. GREEN/WHITE (+)	ABOVE DRIVERS KICK, in a GREEN 43-PIN PLUG, PIN 31
FACTORY ALARM DISARM	N/A
ANTI-THEFT	See NOTE #1

EXTRA INFORMATION

NOTE #1: This vehicle requires a SPECIAL INTERFACE BYPASS MODULE to REMOTE START or do KEYLESS ENTRY without using the resistors, you can choose from 2 models, the DB-ALL or the XK09, to order go to the INTERFACE BYPASS MODULE Page on this website.