| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | RED (+) | @ IGNITION SWITCH HARNESS |
| STARTER | YELLOW (+) | @ IGNITION SWITCH HARNESS |
| STARTER 2 | N/A | |
| IGNITION 1 | PINK (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 2 | N/A | |
| IGNITION 3 | N/A | |
| ACCESSORY/HEATER BLOWER 1 | ORANGE (+) | @ IGNITION SWITCH HARNESS |
| ACCESSORY/HEATER BLOWER 2 | N/A | |
| KEYSENSE | N/A | |
| PARKING LIGHTS ( - ) | BLACK/WHITE (-) | @ BCM, BLUE Plug, in PASSENGER KICK |
| PARKING LIGHTS ( + ) | BROWN (+) | @ BCM, BLUE Plug, in PASSENGER KICK |
| POWER LOCK | RED/BLACK (TYPE B) | @ BCM, in PASSENGER KICK |
| POWER UNLOCK | TAN and GREY/BLACK, (TYPE C), See NOTE #2 | @ BCM, in PASSENGER KICK |
| DOOR TRIGGER | GREY/BLACK and BLACK/WHITE (-) See NOTE #3 | @ BCM, in PASSENGER KICK PANEL |
| DOMELIGHT SUPERVISION | GREY/BLACK and BLACK/WHITE (-) (Requires #775 relay) | @ BCM, in PASSENGER KICK PANEL |
| TRUNK RELEASE | BROWN (+) | @ BCM, BLUE Plug, in PASSENGER KICK |
| SLIDING POWER DOOR | N/A | |
| HORN | BLACK (-) | @ STEERING COLUMN HARNESS |
| TACH | WHITE (AC) | @ PCM, BLUE Plug, See NOTE #4 |
| WAIT TO START LIGHT | N/A | |
| BRAKE | LIGHT BLUE (+) | @ SWITCH ABOVE BRAKE PEDAL |
| FACTORY ALARM DISARM | DISARMS WITH FACTORY REMOTE CONTROL ONLY | |
| ANTI-THEFT | 2 THIN WHITE wires in ORANGE Tubing | VATS (PASSKEY) at STEERING COLUMN |
| EXTRA INFORMATION |
| NOTE #1: If vehicle is equipped with PASSKEY/VATS, Ignition Key will have a little Chip on the Steel Shaft of the Key that can be seen. Requires 791 Bypass Module for Remote starting to order go to the SECURITY BYPASS MODULE Page on this website. NOTE #2: The TAN wire will UNLOCK the DRIVERS door and the GREY/BLACK will UNLOCK the PASSENGER door. Both wires must be wired in as a TYPE C SYSTEM and use a relay for each wire. NOTE #3: This vehicle uses (2) separate door triggers wires, when installing a ALARM SYSTEM use both wires and DIODE ISOLATE. NOTE #4: The PCM (Power Control Module) is located under the hood on the PASSENGER inner fender at the FIREWALL. On the V-6 the TACH wire is located in Pin 54, and on the V-8 it is in Pin 10 |