Chevrolet  Camaro 1996-1999
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   RED (+)   @ IGNITION SWITCH HARNESS
 STARTER  YELLOW (+)  @ IGNITION SWITCH HARNESS
 STARTER 2  N/A  
 IGNITION 1  PINK (+)  @ IGNITION SWITCH HARNESS
 IGNITION 2  N/A  
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  ORANGE (+)  @IGNITION SWITCH HARNESS
 ACCESSORY/HEATER BLOWER 2  N/A  
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  N/A  
 PARKING LIGHTS ( + )  BROWN (+)  IN DRIVERS KICK PANEL
 POWER LOCK  RED/BLACK (TYPE B)  @ BCM, in PASSENGER KICK
 POWER UNLOCK  TAN and GREY/BLACK, (TYPE C), See NOTE #2  @ BCM, in PASSENGER KICK
 DOOR TRIGGER  GREY/BLACK and BLACK/WHITE (-) See NOTE #3  @ BCM, in PASSENGER KICK PANEL
 DOMELIGHT SUPERVISION  GREY/BLACK and BLACK/WHITE (-) (Requires #775 relay)  @ BCM, in PASSENGER KICK PANEL
 TRUNK RELEASE  BLACK/WHITE (+)  @ RELAY near PASSENGER KICK PANEL
 SLIDING POWER DOOR  N/A  
 HORN  BLACK (-)  @ STEERING COLUMN HARNESS
 TACH  WHITE or RED/BLACK, (AC), See NOTE #4  @ COIL/DISTRIBUTOR ASSEMBLY
 WAIT TO START LIGHT  N/A  
 BRAKE  LIGHT BLUE (+)  @ SWITCH ABOVE BRAKE PEDAL
 FACTORY ALARM DISARM   N/A  
 ANTI-THEFT  (2) THIN WHITE wires in ORANGE Tubing  VATS (PASSKEY) at STEERING COLUMN
 EXTRA INFORMATION
 NOTE #1: If vehicle is equipped with PASSKEY/VATS, Ignition Key will have a little Chip on the Steel Shaft of the Key that can be seen. Requires 791 Bypass Module for Remote starting to order go to the SECURITY BYPASS MODULE Page on this website. NOTE #2: The TAN wire will UNLOCK the DRIVERS door and the GREY/BLACK will UNLOCK the PASSENGER door. Both wires must be wired in as a TYPE C SYSTEM and use a relay for each wire. NOTE #3: This vehicle uses (2) separate door triggers wires, when installing a ALARM SYSTEM use both wires and DIODE ISOLATE. NOTE #4: The TACH wire on the V-6 is a WHITE at the LEFT FRONT cylinder head. On the V-8 the TACH wire is in a 4-Pin plug at the PASSENGER side valve cover.