Cadillac  Escalade 2007-
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   (2) RED/BLACK (+)   @ FUSE BOX
 STARTER  See NOTE #1  
 STARTER 2  N/A  
 IGNITION 1  PINK (+)  @ IGNITION SWITCH HARNESS or BCM, LIGHT GREEN Plug, Pin 14, See NOTE #2
 IGNITION 2  N/A  
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  BROWN (+)  @ IGNITION SWITCH HARNESS or BCM, LIGHT GREEN Plug, Pin 21, See NOTE #2
 ACCESSORY/HEATER BLOWER 2  N/A  
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  LIGHT BLUE (-)  @ HEAD LIGHT Switch or BCM, NATURAL Plug, Pin 8, See NOTE #2
 PARKING LIGHTS ( + )  N/A  
 POWER LOCK  See NOTE #1  
 POWER UNLOCK  See NOTE #1  
 DOOR TRIGGER  See NOTE #3  
 DOMELIGHT SUPERVISION  GRAY (+)  @ BCM, NATURAL Plug, Pin 5, See NOTE #2
 TRUNK RELEASE  PINK (-) Glass and GRAY (-) Gate See NOTE #4  @ BCM, PINK Plug, Pins 24 and 13, See NOTE #2
 SLIDING POWER DOOR  N/A  
 HORN  TAN (-)  @ HORN Switch or BCM, BROWN Plug, Pin 18, See NOTE #2
 TACH  ANY wire NOT PINK, BROWN or BLACK (AC)  @ ANY FUEL-INJECTOR or IGNITION COIL
 WAIT TO START LIGHT  N/A  
 BRAKE  LIGHT BLUE/WHITE (+)  @ SWITCH ABOVE BRAKE or BCM, BROWN Plug, Pin 6, See NOTE #2
 FACTORY ALARM DISARM   LIGHT GREEN (-)  @ DRIVERS DOOR MODULE, BROWN 16-Pin Plug, Pin 4
 ANTI-THEFT  GM'S MULTIPLEX IGNITION/TRANSPONDER SYSTEM, See NOTE #1  
 EXTRA INFORMATION
 NOTE #1: THIS VEHCILE REQUIRES A SPECIAL INTERFACE BYPASS MODULE FOR REMOTE START AND KEYLESS ENTRY PART #DB-ALL or XK09 and will also need PART #RFLCHGM , TO ORDER GO TO THE INTERFACE BYPASS MODULE PAGE ON THIS WEBSITE. NOTE #2: The BCM (Body Control Module) is located to the LEFT of the STEERING COLUMN. NOTE #3: The DRIVERS DOOR TRIGGER is a GRAY/BLACK (-) at the DRIVERS DOOR MODULE in the DRIVERS DOOR, BROWN 16-Pin Plug, Pin 13, the PASSENGER DOOR TRIGER is a BLACK/WHITE (-) at the PASSENGER DOOR MODULE in the PASSENGER DOOR, BROWN 16-Pin Plug, Pin 13. The DRIVERS REAR DOOR TRIGGER is a LIGHT BLUE/BLACK (-) PINK Plug, Pin 15 and the PASSENGER REAR DOOR TRIGGER is a LIGHT GREEN/BLACK (-) PINK Plug, Pin 14 both wires are located in the PINK Plug on the BCM, when connecting to an ALARM SYSTEM use all (4) FOUR wires and DIODE ISOLATE, See DIAGRAM. NOTE #4: TEST these wires while OPENING the LIFTGLASS and LIFTGATE from the HANDLE on the REAR HATCH of the vehicle.