PART | COLOR | LOCATION |
12 VOLT CONSTANT | RED (+) | @ IGNITION SWITCH HARNESS |
STARTER | YELLOW (+) | @ IGNITION SWITCH HARNESS |
STARTER 2 | N/A | |
IGNITION 1 | PINK (+) | @ IGNITION SWITCH HARNESS |
IGNITION 2 | LIGHT BLUE (+) | @ IGNITION SWITCH HARNESS |
IGNITION 3 | N/A | |
ACCESSORY/HEATER BLOWER 1 | ORANGE (+) | @ IGNITION SWITCH HARNESS |
ACCESSORY/HEATER BLOWER 2 | N/A | |
KEYSENSE | N/A | |
PARKING LIGHTS ( - ) | GREY/BLACK (-) | IN DRIVERS KICK PANEL |
PARKING LIGHTS ( + ) | PURPLE (+) | @ the PARKING LIGHT RELAY, See NOTE #2 |
POWER LOCK | RED/BLACK (TYPE B) | @ BCM, Plug C1, See NOTE #3 |
POWER UNLOCK | ORANGE/BLACK (TYPE B) | @ BCM, Plug C1, See NOTE #3 |
DOOR TRIGGER | See NOTE #4 | @ BCM, Plugs C1 and C2, See NOTE #3 |
DOMELIGHT SUPERVISION | TAN (-) | @ BCM, Plug C2, See NOTE #3 |
TRUNK RELEASE | BLACK/WHITE (+) | @ TRUNK RELEASE RELAY, See NOTE #5 |
SLIDING POWER DOOR | N/A | |
HORN | BLACK (-) | @ STEERING COLUMN HARNESS |
TACH | PURPLE/WHITE (AC) | @ 5 Pin PLug, rear of engine |
WAIT TO START LIGHT | N/A | |
BRAKE | LIGHT BLUE (+) | @ SWITCH ABOVE BRAKE PEDAL |
FACTORY ALARM DISARM | LIGHT GREEN (-) | IN EITHER KICK PANEL |
ANTI-THEFT | 2 WHITE wires or 1 WHITE and 1 PURPLE or PURPLE/WHITE in an ORANGE or BLACK TUBE in RUNNING DOWN STEERING COLUMN | @ Ignition Switch |
EXTRA INFORMATION |
NOTE #1: If vehicle is equipped with PASSKEY/VATS, Ignition Key will have a little Chip on the Steel Shaft of the Key that can be seen. Requires 791 Bypass Module for Remote starting to order go to the SECURITY BYPASS MODULE Page on this website. NOTE #2: the parking Light wire is located in the Trunk Compartment #2 Micro Relay Center behind the Rear Seat DO NOT use any other wire that tests as a (+) PARKING LIGHT wire in this vehicle. NOTE #3: the BCM is located behind the Drivers side of the Rear Seat back, it has (2) plugs labled C1 and C2. NOTE #4: the DRIVERS DOOR use the TAN (-) Plug C2, the PASSENGER DOOR uses the DARK BLUE/WHITE (-) Plug C1 and both REAR DOORS use (1) wire a ORANGE (-) Plug C1, when connecting to an Alarm System, use all (3) wires and DIODE ISOLATE. See DIAGRAM NOTE #5: the Trunk Release Relay is located in the Trunk at the #1 Micro Relay Center. |