PART | COLOR | LOCATION |
12 VOLT CONSTANT | Connect to BATTERY ONLY | |
STARTER | YELLOW (+) | @ IGNITION SWITCH HARNESS |
STARTER 2 | N/A | |
IGNITION 1 | PINK (+) | @ IGNITION SWITCH HARNESS |
IGNITION 2 | WHITE (+) | @ IGNITION SWITCH HARNESS |
IGNITION 3 | N/A | |
ACCESSORY/HEATER BLOWER 1 | ORANGE (+) | @ IGNITION SWITCH HARNESS |
ACCESSORY/HEATER BLOWER 2 | N/A | |
KEYSENSE | N/A | |
PARKING LIGHTS ( - ) | GRAY/BLACK (-) | @ LCM, GREY Plug, Pin B11, See NOTE #2 |
PARKING LIGHTS ( + ) | BROWN (+) | @ LCM, BLACK Plug, Pin A, See NOTE #2 |
POWER LOCK | RED/BLACK (TYPE B) | @ DRIVERS DOOR LOCK SWITCH in drivers door |
POWER UNLOCK | ORANGE/BLACK (TYPE B) | @ DRIVERS DOOR LOCK SWITCH in drivers door |
DOOR TRIGGER | See NOTE #3 | @ the DOOR MODULES |
DOMELIGHT SUPERVISION | GRAY (-), (Requires #775 Relay) | @ UNDERDASH LIGHT |
TRUNK RELEASE | BLACK (-), (Requires #775 Relay) | @ TRUNK RELEASE SWITCH |
SLIDING POWER DOOR | N/A | |
HORN | BLACK (-) | @ STEERING COLUMN HARNESS |
TACH | WHITE (AC) | @ PCM, See NOTE #4 |
WAIT TO START LIGHT | N/A | |
BRAKE | LIGHT BLUE (+) | @ SWITCH ABOVE BRAKE PEDAL |
FACTORY ALARM DISARM | LIGHT GREEN (-) | IN DRIVERS DOOR MODULE in DOOR, BLACK 12 PIN PLUG, Pin K |
ANTI-THEFT | GM'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 | TRANSPONDER @ IGNITION SWITCH TUMBLER |
EXTRA INFORMATION |
NOTE #1: Equipped with GM's PK3 TRANSPONDER ANTI-THEFT System Requires part # 791 BYPASS MODULE and an extra ignition key for Remote Starting operation to order go to the SECURITY BYPASS MODULE Page on this website. NOTE #2: The LAMP CONTROL Module is located to the RIGHT of the steering column and is bolted to the back side of the dash. NOTE #3: use the TAN (-) in the DRIVERS DOOR at the DOOR Module, BLACK 12-pin plug, Pin C. For the PASSENGER DOOR, use the LIGHT GREEN (-) in the PASSENGER DOOR at the DOOR Module, BLACK 12-pin plug pin C. the DRIVERS REAR DOOR is a DARK BLUE/WHITE (-) and the PASSENGER REAR DOOR is a YELLOW/BLACK (-) located at the REAR DOOR MODULE under the REAR SEAT, GRAY Plug, pins A7 and A5, when connecting to an ALARM SYSTEM, use all 4 WIRES and DIODE ISOLATE, See DIAGRAM. NOTE #4: the PCM is under the hood in the AIR CLEANER HOUSING, in a CLEAR Plug pin 8. |