Buick  Park Avenue 1996-
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   RED (+)   @ IGNITION SWITCH HARNESS
 STARTER  YELLOW (+)  @ IGNITION SWITCH HARNESS
 STARTER 2  N/A  
 IGNITION 1  PINK (+)  @ IGNITION SWITCH HARNESS
 IGNITION 2  N/A  
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  ORANGE (+)  @ IGNITION SWITCH HARNESS
 ACCESSORY/HEATER BLOWER 2  N/A  
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  N/A  
 PARKING LIGHTS ( + )  BROWN (+)  LOW in DRIVERS KICK PANEL
 POWER LOCK  RED/BLACK (TYPE B)  IN EITHER DOOR BOOT
 POWER UNLOCK  ORANGE/BLACK (TYPE B)  IN EITHER DOOR BOOT
 DOOR TRIGGER  TAN (-) and DARK BLUE (-) Use both wires, See NOTE #2  IN DRIVERS KICK PANEL
 DOMELIGHT SUPERVISION  LIGHT GREEN/BLACK (-)  @ BCM, See NOTE #3
 TRUNK RELEASE  BLACK/WHITE (+)  @ TRUNK RELEASE SWITCH
 SLIDING POWER DOOR  N/A  
 HORN  BLACK (-)  @ STEERING COLUMN HARNESS
 TACH  PURPLE/WHITE or WHITE (AC)  @ IGNITION CONTROL MODULE
 WAIT TO START LIGHT  N/A  
 BRAKE  LIGHT BLUE or WHITE (+)  @ SWITCH ABOVE BRAKE PEDAL
 FACTORY ALARM DISARM   LIGHT GREEN (-)  IN EITHER DOOR HARNESS
 ANTI-THEFT  2 WHITE wires in a ORANGE or BLACK heat shrunk tube in Steering column harness  GM's VATS System @ Ignition Switch
 EXTRA INFORMATION
 NOTE #1: If vehicle is equipped with PASSKEY/VATS, Ignition Key will have a little Chip on the Steel Shaft of the Key that can be seen. Requires 791 Bypass Module for Remote starting to order go to the SECURITY BYPASS MODULE Page on this website. NOTE #2: The TAN (-) wire is the DRIVERS DOOR located in the drivers door harness. the DARK BLUE (-) is located LOW in the DRIVERS KICK PANEL and it is for all other doors. for an alarm use both and diode isolate. See DIAGRAM NOTE #3: The BCM is located behind the GLOVEBOX with the wires exiting down.