Note #1: the ECM (Engine Control Module) is located in the Engine Compartment, on the front
of the motor
Note #2: the BCM, (Body control Module) is located under the Driver side Dash and to the LEFT
of the Steering Column
Note #3: On vehicles with Express Up and Down Power Windows, these wires are not present.
To do door locks on these vehicles, you have to Reverse Polarity the Door Lock Motor
wires in each Front Doors and Trigger the Rear doors Lock/Unlock wires. The Door
Lock Motor wires are GRAY - TAN at each Front Window Switch, (BROWN, 16 Pin Plug)
Pins 7 and 8. The Rear Doors Power LOCK is LT. GREEN (+) @ the BCM, (GRAY Plug)
Pin 7. The Rear Doors Power UNLOCK is LT. BLUE (-) @ the BCM, (GRAY Palug) Pin 9.
Note #4: On vehicles with Express Up and Down Power Windows, this wire is at the Drivers
window Switch, (BROWN 16 Pin Plug) Pin 13.
Note #5: Meter this wire while Opening the LIFTGATE from the Handle on the Rear of the Vehicle.
On Vehicles with Power Liftgate, the Open/Close wire is a DK. GREEN/WHITE @ the
Switch in the Dash or the LGM (Lift Gate Module) in the Drivers Side Rear Quarter Panel.
Note #6: You can also use the BROWN wire @ the ECM, (BLACK 96 Pin PLug X1) Pin 51.
Note #7: Meter this wire while turning the Key in the Drivers Door Key Cylinder.
On vehicles with Express Up and Down Power Windows, this wire is at the Drivers
Window Switch, (BROWN 16 Pin Plug) Pin 4.
Note #8: THIS VEHICLE REQUIRES A SPECIAL INTERFACE BYPASS MODULE, (2) BYPASS
MODULES WILL WORK ON THIS VEHICLE THE XK09 OR THE DB-ALL, EITHER BYPASS
WILL ALSO REQUIRE THE RFLCHGM TO REMOTE START, TO ORDER GO TO THE
INTERFACE BYPASS MODULE PAGE ON THIS WEBSITE.
|