PART | COLOR | LOCATION |
12 VOLT CONSTANT | RED/BLUE (+) and RED/GREEN (+) | @ IGNITION SWITCH HARNESS |
STARTER | BLACK/BLUE (+) | @ IGNITION SWITCH HARNESS |
STARTER 2 | N/A | |
IGNITION 1 | GREEN (+) | @ IGNITION SWITCH HARNESS |
IGNITION 2 | PURPLE (+) | |
IGNITION 3 | N/A | |
ACCESSORY/HEATER BLOWER 1 | N/A | |
ACCESSORY/HEATER BLOWER 2 | N/A | |
KEYSENSE | N/A | |
PARKING LIGHTS ( - ) | N/A | |
PARKING LIGHTS ( + ) | GRAY/PURPLE (+) Left and GRAY/YELLOW (+) Right, Use Both, See NOTE #1 | @ LIGHT SWITCH Module, Pins 29 and 30 See NOTE #1 |
POWER LOCK | YELLOW/RED (TYPE B), See NOTE #2 | @ GENERAL MODULE, Middle Plug, Pin 7, See NOTE #3 |
POWER UNLOCK | Same wire as LOCK, See NOTE #2 | |
DOOR TRIGGER | See NOTE #4 | @ GENERAL MODULE, Middle Plug, Pins 25 and 26, See NOTE #3 |
DOMELIGHT SUPERVISION | RED/BLUE (+) | @ GENERAL MODULE, Middle Plug, Pin 18, See NOTE #3 |
TRUNK RELEASE | GRAY/BROWN (-) | @ GENERAL MODULE, Middle Plug, Pin 17, See NOTE #3 |
SLIDING POWER DOOR | N/A | |
HORN | PURPLE/BLUE (+) | @ HORNS under the HOOD |
TACH | BLACK (AC) | @ OBD Plug under Drivers Dash, Pin 9 |
WAIT TO START LIGHT | N/A | |
BRAKE | BLUE/RED (+), See NOTE #5 | @ SWITCH above BRAKE PEDAL |
FACTORY ALARM DISARM | WHITE/BLACK (-), See NOTE #6 | @ GENERAL MODULE, Middle Plug, Pin 20, See NOTE #3 |
ANTI-THEFT | BMW'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #7 | @ IGNITION SWITCH TUMBLER |
EXTRA INFORMATION |
NOTE #1: The Parking Lights on this vehicle have (2) seperate circuits, to connect will require (2) extra Relays Part #775, to connect See DIAGRAM. The LIGHT SWITCH Module is part of the HEADLIGHT Switch. NOTE #2: The LOCK and UNLOCK use the SAME wire, a (-) Negative or TYPE "B" pulse on this wire, will alternate between the LOCK and UNLOCK on the vehicle. NOTE #3: The GENERAL MODULE is located behind the GLOVEBOX on this vehicle. NOTE #4: The DRIVERS DOOR TRIGGER is a BROWN/GRAY/YELLOW (-) at Pin 26, the PASSENGER DOOR TRIGER is a BROWN/GRAY/YELLOW (-) at Pin 25. , when connecting to an ALARM SYSTEM use both wires and DIODE ISOLATE, See DIAGRAM. NOTE #5: This wire will only TEST with the IGNITION "ON". NOTE #6: TEST this wire while turning the Key in the Drivers Door Key Cylinder. This wire will also UNLOCK the Doors. On some Models, this wire will require a Double Pulse to UNLOCK the Doors. NOTE #7: BMW'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, Part # 791 Bypass and an extra ignition key for REMOTE STARTING Operation. To order go to the SECURITY BYPASS MODULE Page on the website. |