Acura  TL 2004-2008
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   WHITE (+)   @ IGNITION SWITCH HARNESS
 STARTER  BLACK/WHITE (+)  @ IGNITION SWITCH HARNESS
 STARTER 2  N/A  
 IGNITION 1  BLACK/YELLOW (+)  @ IGNITION SWITCH HARNESS
 IGNITION 2  N/A  
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  BLACK/RED (+)  @ IGNITION SWITCH HARNESS
 ACCESSORY/HEATER BLOWER 2  WHITE/RED (+)  @ IGNITION SWITCH HARNESS
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  RED/BLACK (-)  @ HEADLIGHT SWITCH
 PARKING LIGHTS ( + )  RED/BLACK (+)  @ TOP of FUSE BOX, LARGE WHITE PLUG
 POWER LOCK  PINK/BLACK (TYPE B)  LEFT Side of FUSE BOX, GREEN PLUG, See NOTE #2
 POWER UNLOCK  PINK/BLUE (TYPE B)  LEFT Side of FUSE BOX, GREEN PLUG, See NOTE #2
 DOOR TRIGGER  See NOTE #3  @ REAR of FUSE BOX
 DOMELIGHT SUPERVISION  GREEN/RED (-) (Requires #775 Relay)  @ REAR of FUSE BOX, GREEN, 5-PIN PLUG
 TRUNK RELEASE  YELLOW/GREEN or BLUE/BLACK (+)  in DRIVERS KICK, HARNESS to REAR of Vehicle
 SLIDING POWER DOOR  N/A  
 HORN  GREEN/YELLOW (-)  @ HORN SWITCH
 TACH  Any wire NOT YELLOW/BLACK (AC)  @ Any FUEL-INJECTOR
 WAIT TO START LIGHT  N/A  
 BRAKE  WHITE/BLACK (+)  @ BRAKE PEDAL SWITCH
 FACTORY ALARM DISARM   BLACK/RED to WHITE (-)  @ DRIVERS DOOR MODULE, in DOOR
 ANTI-THEFT  ACURA'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1  @ IGNITION SWITCH TUMBLER
 EXTRA INFORMATION
 NOTE #1: ACURA'S TRANSPONDER SYSTEM, Requires Bypass Module: (For Remote Starting Only) Part #791 Bypass, (Requires Extra Key) for Operation. (For Remote Starting Only) Part # PK-ALL Bypass. (No Extra Key Required for Operation) 2-KEYS Required to Program Module. To order please go to the SECURITY BYPASS MODULE Page or INTERFACE BYPASS MODULE Page on this website. NOTE #2: TEST these wires with the Passenger Door Lock Switch. NOTE #3: The DRIVERS FRONT Door is a GREEN (-) in a 16-Pin Plug, Pin 15, the PASSENGER FRONT Door is a LT.GREEN/RED (-) in a 14-Pin Plug, Pin 12. The DRIVERS REAR Door is a GREEN/YELLOW (-) in a 16-Pin Plug, Pin 14 and the PASSENGER REAR Door is a GREEN/WHITE (-) in a 14-Pin Plug, Pin 13. when installing an Alarm use all 4 wires and Diode Isolate.