| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | Connect to BATTERY ONLY | |
| STARTER | GRAY/BLACK (+) | IGNITION SWITCH HARNESS |
| STARTER 2 | N/A | |
| IGNITION 1 | GREEN/WHITE (+) | IGNITION SWITCH HARNESS |
| IGNITION 2 | N/A | |
| IGNITION 3 | N/A | |
| ACCESSORY/HEATER BLOWER 1 | YELLOW (+) | IGNITION SWITCH HARNESS |
| ACCESSORY/HEATER BLOWER 2 | N/A | |
| KEYSENSE | RED/GREEN (-) (Required for Remote Starting) | IGNITION SWITCH HARNESS |
| PARKING LIGHTS ( - ) | BLACK/BLUE (-) | @ HEADLIGHT SWITCH or CEM, Pin B4, See NOTE *1 |
| PARKING LIGHTS ( + ) | DO NOT USE! | |
| POWER LOCK | BLACK/RED (TYPE B) | @ DOOR LOCK SWITCH or DDM, Pin A6, See NOTE *2 |
| POWER UNLOCK | BLACK/YELLOW (TYPE B) | @ DOOR LOCK SWITCH or DDM, Pin A7, See NOTE *2 |
| DOOR TRIGGER | See NOTE *3 | @ CEM Module, See NOTE *1 |
| DOMELIGHT SUPERVISION | BLACK (-) | @ UNDER DASH LIGHT or CEM, Pin A25, See NOTE *1 |
| TRUNK RELEASE | BLACK/YELLOW (-) | @ CEM Module, Pin F22, See NOTE *1 |
| SLIDING POWER DOOR | N/A | |
| HORN | BLACK/BLUE (-) | @ CEM Module, Pin G18, See NOTE *1 |
| TACH | ANY wire NOT GREEN/YELLOW | @ ANY FUEL-INJECTOR |
| WAIT TO START LIGHT | N/A | |
| BRAKE | ORANGE (+) | @ CEM Module, Pin E41, See NOTE *1 |
| FACTORY ALARM DISARM | N/A | |
| ANTI-THEFT | TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY | TRANSPONDER @ IGNITION SWITCH TUMBLER |
| EXTRA INFORMATION |
| NOTE *1 the CEM (Central Electronic Module) is located BEHIND the GLOVE BOX. NOTE *2 the DDM (Drivers Door Module) is located INSIDE the DRIVERS DOOR and is attached to the DRIVERS POWER WINDOW MOTOR. NOTE *3 the DRIVERS DOOR is a BLACK/YELLOW(-) Pin F19, the PASSENGER DOOR is a BLACK/BLUE (-) Pin F18, the DRIVERS REAR DOOR is a BLACK/ORANGE (-) Pin F21, and the PASSENGER REAR DOOR is a BLACK/BLUE (-) Pin F20. When connecting to an ALARM SYSTEM, use all (4) DOOR TRIGGER wires and DIODE ISOLATE. to connect, See DIAGRAM |