| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | RED (+) (10 Gauge wire) | IGNITION SWITCH HARNESS, See NOTE *1 |
| STARTER | RED/BLACK (+) (10 Gauge wire) | IGNITION SWITCH HARNESS, See NOTE *1 |
| STARTER 2 | N/A | |
| IGNITION 1 | BLACK (+) (16 Gauge wire) | IGNITION SWITCH HARNESS, See NOTE *1 |
| IGNITION 2 | N/A | |
| IGNITION 3 | N/A | |
| ACCESSORY/HEATER BLOWER 1 | BLACK/YELLOW (+) (12 Gauge wire) | IGNITION SWITCH HARNESS, See NOTE *1 |
| ACCESSORY/HEATER BLOWER 2 | N/A | |
| KEYSENSE | N/A | |
| PARKING LIGHTS ( - ) | N/A | |
| PARKING LIGHTS ( + ) | GRAY/BLACK (+) and GRAY/RED (+) Use both, See NOTE *1 | @ HEADLIGHT SWITCH, See DIAGRAM |
| POWER LOCK | YELLOW/RED or GRAY (TYPE A) | IN DRIVERS KICK PANEL, at DOOR HARNESS |
| POWER UNLOCK | RED/BLACK or GREEN (TYPE A) (Requires Double Pulse) | IN DRIVERS KICK PANEL, at DOOR HARNESS |
| DOOR TRIGGER | BROWN/WHITE (-) | IN DRIVERS KICK PANEL or @ ALARM MODULE, See NOTE *4 |
| DOMELIGHT SUPERVISION | USE DOOR TRIGGER | IN DRIVERS KICK PANEL |
| TRUNK RELEASE | GRAY (+) See NOTE *3 | @ TRUNK RELEASE SWITCH, See DAIGRAM |
| SLIDING POWER DOOR | N/A | |
| HORN | BLACK/YELLOW (+) | BEHIND FUSE BOX |
| TACH | BLACK/RED | @ IGNITION COIL |
| WAIT TO START LIGHT | N/A | |
| BRAKE | RED/BLACK (+) | @ SWITCH ABOVE BRAKE PEDAL |
| FACTORY ALARM DISARM | DISARMS WITH UNLOCK, Single Pulse Disarms | |
| ANTI-THEFT | N/A |
| EXTRA INFORMATION |
| NOTE *1 the IGNITION HARNESS is a BIG LOOP at THE BACK of the FUSE BOX. NOTE *2 the HIDDEN RELEASE TAB for the HEADLIGHT SWITCH, is on the UPPER LEFT SIDE of the SWITCH. You MUST CUT both of the PARKING LIGHT WIRES and ISOLATE the SWITCH SIDE of the wires with a RELAY PART #775 so that the switch does not see (+) 12 volts. You can also use the HAZARD WIRES, the BLACK/WHITE and BLACK/GREEN these are (+) POSITIVE WIRE and are located at the STEERING COLUMN. See DIAGRAM NOTE *3 the GRAY wire is GROUNDED by the HATCH RELEASE SWITCH at rest, cut this wire in half and use a EXTRA RELAY, PART #775 to isolate the switch side of the trunk release wire from seeing (+) 12volts. to connect, See DIAGRAM. NOTE *4 the ALARM MODULE is located BEHIND the HEADLIGHT Switch. |