Toyota Land Cruiser 2008-2011 Printer Friendly Wiring Chart

Toyota Land Cruiser 2008-2011

PART	COLOR	LOCATION
12 VOLT CONSTANT	BLACK (+)	@ DRIVERS DASH FUSE BOX, (WHITE, 1-Pin Plug(A) Pin 1
STARTER	SEE NOTE #1
STARTER 2	N/A
IGNITION 1	SEE NOTE #1
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	SEE NOTE #1
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	PURPLE (-)	@ HEADLIGHT SWITCH or BECU, (WHITE, 26-Pin Plug) Pin 23, NOTE #6
PARKING LIGHTS ( + )	GREEN (+)	@ DRIVERS DASH FUSE BOX, (WHITE, 24-Pin Plug(C) Pin 22
POWER LOCK	RED (TYPE B), (TEST with Passenger Switch), NOTE #2	@ DRIVERS DASH FUSE BOX, (WHITE, 66-Pin Plug(D) Pin 49
POWER UNLOCK	GREEN (TYPE B), (TEST with Passenger Switch), NOTE #3	@ DRIVERS DASH FUSE BOX, (WHITE, 66-Pin Plug(D) Pin 52
DOOR TRIGGER	BLUE (-)	@ BECU, (WHITE, 26-Pin Plug) Pin 24, NOTE #6
DOMELIGHT SUPERVISION	GREEN (-)	@ DRIVERS DASH FUSE BOX, (WHITE, 66-Pin Plug(D) Pin 51
TRUNK RELEASE	BLUE (-) NOTE #4	@ BECU, (WHITE, 26-Pin Plug) Pin 26, NOTE #6
SLIDING POWER DOOR	N/A
HORN	GRAY to RED/WHITE (-)	@ HORN SWITCH or DRIVERS DASH FUSE BOX, (WHITE, 24-Pin Plug(B) Pin 1
TACH	WHITE (AC)	@ DATA LINK Connector, (WHITE, 16-Pin Plug) Pin 9 or BECU, (WHITE, 16-Pin Plug) Pin 8, NOTE #6
WAIT TO START LIGHT	N/A
BRAKE	RED (+)	@ BRAKE SWITCH or DRIVERS DASH FUSE BOX, (WHITE, 24-Pin Plug(B) Pin 22
FACTORY ALARM DISARM	YELLOW (-) (Requires Double Pulse), NOTE #7	@ BECU, (WHITE, 26-Pin Plug) Pin 10, NOTE #6
ANTI-THEFT	TOYOTA'S MULTIPLEX IGNITION/TRANSPONDER SYSTEM, See NOTE #1

EXTRA INFORMATION

NOTE #1: This vehicle has a MULTIPLEX IGNITION CIRCUIT/ANTI-THEFT SYSTEM that Requires a Special INTERFACE BYPASS MODULE Part # DB-ALL to REMOTE START, to order please go to the INTERFACE BYPASS MODULE Page on this website. NOTE #2: this wire is only needed if the Door Locks do not function with the Aftermarket System while the vehicle is running. All other times just use the Factory Alarm Arm wire. NOTE #3: this wire is only needed if the Door Locks do not function with the Aftermarket System while the vehicle is running. All other times just use the Factory Alarm Disarm wire. NOTE #4: TEST this wire while opening the Liftgate from the Handle on the Rear of the Vehicle. NOTE #5: TEST this wire while turning the Key in the Drivers Door, this wire will also Unlock the Doors. NOTE #6: the BECU is located under the Driver Dash, attached to the Fuse Box. NOTE #7: TEST this wire while turning the Key in the Drivers Door, this wire will also Unlock the Doors.