| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | Connect to BATTERY ONLY | |
| STARTER | BLACK/WHITE (+) | @ IGNITION SWITCH HARNESS |
| STARTER 2 | N/A | |
| IGNITION 1 | BLACK/RED (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 2 | BLUE/BLACK (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 3 | N/A | |
| ACCESSORY/HEATER BLOWER 1 | BLACK (+) | @ IGNITION SWITCH HARNESS |
| ACCESSORY/HEATER BLOWER 2 | N/A | |
| KEYSENSE | RED/BLACK (-) | @ IGNITION SWITCH HARNESS |
| PARKING LIGHTS ( - ) | GREEN/BLACK (-) | @ BECU,26-PIN PLUG, PIN 8, See NOTE #2 |
| PARKING LIGHTS ( + ) | GREEN (+) | @ BECU, 30-PIN PLUG, PIN 28, See NOTE #2 |
| POWER LOCK | BLUE/WHITE (TYPE B), See NOTE #3 | @ 42-PIN PLUG, BOTTOM of FUSEBOX |
| POWER UNLOCK | GREEN/BLACK (TYPE B), See NOTE #3 | @ 42-PIN PLUG, BOTTOM of FUSEBOX |
| DOOR TRIGGER | See NOTE #4 | @ BECU, 24-PIN PLUG, See NOTE #2 |
| DOMELIGHT SUPERVISION | GREEN/WHITE (-), (Requires Part #775 Relay) | @ DRIVERS FUSEBOX, TOP LEFT, 20-PIN PLUG |
| TRUNK RELEASE | N/A | |
| SLIDING POWER DOOR | N/A | |
| HORN | GREEN/ORANGE (-) | @ DRIVERS FUSEBOX, TOP, 25-PIN PLUG |
| TACH | BLACK (AC) | @ DATA LINK CONNECTOR, UNDER DRIVERS DASH |
| WAIT TO START LIGHT | N/A | |
| BRAKE | GREEN/WHITE (+) | @ SWITCH ABOVE BRAKE PEDAL |
| FACTORY ALARM DISARM | DISARMS with KEYSENSE wire | @ IGNITION SWITCH HARNESS |
| ANTI-THEFT | TOYOTA'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 | @ IGNITION SWITCH TUMBLER |
| EXTRA INFORMATION |
| NOTE #1: TOYOTA'S TRANSPONDER SYSTEM, Requires Bypass Module: (For Remote Starting Only) Part #791 Bypass, (Requires Extra Key) for Operation. (For Remote Starting Only) Part # PK-ALL Bypass. (No Extra Key Required for Operation) 2-KEYS Required to Program Module. To order please go to the SECURITY BYPASS MODULE Page or INTERFACE BYPASS MODULE Page on this website. NOTE #2: THE BECU (Body Electronic Control Unit) IS ATTACHED TO THE BACK OF THE FUSEBOX IN THE DRIVERS KICK PANEL. NOTE #3: WHEN TESTING THE LOCK/UNLOCK WIRES, YOU MUST USE THE KEY IN THE PASSENGER DOOR KEY CYLINDER, THESE WIRES WILL NOT TEST WITH THE POWER DOOR LOCK SWITCH. NOTE #4: LEFT FRONT DOOR IS RED/YELLOW(-) IN PIN 23, RIGHT FRONT DOOR IS RED/BLACK(-) IN PIN 24, LEFT REAR DOOR IS RED/BLUE(-) IN PIN 11, RIGHT REAR DOOR IS RED/GREEN(-) IN PIN 12 . WHEN CONNECTING TO AN ALARM SYSTEM, USE ALL 4 DOOR TIRGGER WIRES AND DIODE ISOLATE, TO CONNECT, SEE DIAGRAM |