NOTE #1: TOYOTA'S TRANSPONDER SYSTEM, Requires Bypass Module:
(For Remote Starting Only) Part #791 Bypass, (Requires Extra Key) for Operation.
(For Remote Starting Only) Part # PK-ALL Bypass. (No Extra Key Required for
Operation) 2-KEYS Required to Program Module.
(For Remote Starting/Door Locks) Part # DB-ALL (No Extra Key Required for Operation)
1-KEY Required for Programming.
To order please go to the SECURITY BYPASS MODULE Page or INTERFACE BYPASS
MODULE Page on this website.
NOTE #2: on vehicles with SMART KEY, PUSH-BUTTON Start, the START Switch 1 wire is
PINK (-) and the START Switch 2 wire is BROWN (-) at the ENGINE Switch
(BLACK, 14-Pin Plug) Pins 7 and 2.
NOTE #3: on vehicles with SMART KEY, PUSH-BUTTON Start, the Ignition wire is a WHITE (+)
@ the DASH FUSE BOX, (REAR, WHITE, 10-Pin Plug(I) Pin 7
NOTE #4: on vehicles with SMART KEY, PUSH-BUTTON Start, the Ignition 2 wire is a LT. BLUE
(+) located at the DASH FUSE BOX, (REAR, WHITE, 10-Pin Plug(I) Pin 9
NOTE #5: on vehicles with SMART KEY, PUSH-BUTTON Start, the ACCESSORY wire is a GRAY (+)
located at the DASH FUSE BOX, (REAR, WHITE, 10-Pin Plug(I) Pin 3
NOTE #6: this wire is only needed if the Door Locks do not function with the Aftermarket System
while the vehicle is running. All other times just use the Factory Alarm Arm wire.
NOTE #7: this wire is only needed if the Door Locks do not function with the Aftermarket System
while the vehicle is running. All other times just use the Factory Alarm Disarm wire.
NOTE #8: TEST this wire while opening the Liftge or Glass from the Handle on the Rear of the
Vehicle. On vehicles with Power Liftgate, the Open/Close wire is a RED (-) @ the
switch on the Dash, (BLUE, 5-Pin Plug) Pin 4.
NOTE #9 TEST this wire while turning the Key in the Drivers Door, this wire will also Unlock
the Doors.
|