NOTE #1: TOYOTA'S TRANSPONDER SYSTEM, Requires Bypass Module:
(For Remote Starting Only) Part #791 Bypass, (Requires Extra Key) for Operation,
2009-2011.
(For Remote Starting Only) Part # PK-ALL Bypass. (No Extra Key Required for
Operation) 2-KEYS Required to Program Module, for Model years 2009-2010 Only!!
(For Remote Starting/Keyless Entry) Part #DB-ALL, (NO Extra Key Required for
Operation) 1-Key Required for Programming, for model year 2011 only!
To order please go to the SECURITY BYPASS MODULE Page or INTERFACE BYPASS
MODULE Page on this website.
NOTE #2: on vehicles with SMART KEY, PUSH-BUTTON Start, the START Switch 1 wire is
BLUE (-) and the START Switch 2 wire is PURPLE (-) at the ENGINE Switch
(BLACK, 14-Pin Plug) Pins 7 and 2.
NOTE #3: on vehicles with SMART KEY, PUSH-BUTTON Start, the Ignition wire is BEIGE to
YELLOW (+) located to the LEFT of the Steering Column, (WHITE, 18-Pin Plug) Pin 11
NOTE #4: on vehicles with SMART KEY, PUSH-BUTTON Start, the Ignition 2 wire is a LT. GREEN
(+) located at the DASH FUSE BOX, (REAR, WHITE, 10-Pin Plug(I) Pin 9
NOTE #5: on vehicles with SMART KEY, PUSH-BUTTON Start, the ACCESSORY wire is a RED (+)
located at the DASH FUSE BOX, (REAR, WHITE, 10-Pin Plug(I) Pin 3
NOTE #6: the BODY ECU is located under the DRIVERS DASH, it is attached to the RIGHT side of
the DASH FUSE BOX.
NOTE #7: this wire is only needed if the Door Locks do not function with the Aftermarket System
while the vehicle is running. All other times just use the Factory Alarm Arm wire.
NOTE #8: this wire is only needed if the Door Locks do not function with the Aftermarket System
while the vehicle is running. All other times just use the Factory Alarm Disarm wire.
NOTE #9: TEST this wire while turning the Key in the Drivers Door, this wire will also Unlock the
doors.
|