| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | RED (+) | IGNITION SWITCH HARNESS |
| STARTER | YELLOW(+) | IGNITION SWITCH HARNESS |
| STARTER 2 | N/A | |
| IGNITION 1 | PINK(+) | IGNITION SWITCH HARNESS |
| IGNITION 2 | GREEN (+) | IGNITION SWITCH HARNESS |
| IGNITION 3 | N/A | |
| ACCESSORY/HEATER BLOWER 1 | ORANGE (+) | IGNITION SWITCH HARNESS |
| ACCESSORY/HEATER BLOWER 2 | N/A | |
| KEYSENSE | LIGHT GREEN (-) See NOTE *1 | IGNITION SWITCH HARNESS |
| PARKING LIGHTS ( - ) | N/A | |
| PARKING LIGHTS ( + ) | BROWN (+) | @ STEERING COLUMN HARNESS |
| POWER LOCK | ORANGE/BLACK (TYPE A) | IN DRIVERS KICK PANEL |
| POWER UNLOCK | RED/BLACK (TYPE A) | IN DRIVERS KICK PANEL |
| DOOR TRIGGER | See NOTE *2 | @ BCM, See NOTE *4 |
| DOMELIGHT SUPERVISION | GRAY/BLACK (-) | @ BCM, See NOTE *4 |
| TRUNK RELEASE | BLACK (+), Requires Part #775 Relay | @ TRUNK RELEASE SWITCH |
| SLIDING POWER DOOR | N/A | |
| HORN | BLACK (-) | @ STEERING COLUMN HARNESS |
| TACH | See NOTE *3 | |
| WAIT TO START LIGHT | N/A | |
| BRAKE | LIGHT BLUE (+) | @ SWITCH ABOVE BRAKE PEDAL |
| FACTORY ALARM DISARM | N/A | |
| ANTI-THEFT | YELLOW (+) and BLACK (-) and WHITE (Not Used) | GM's PASSLOCK 2 System, wires are under the Steering Column cover, at the Bottom of the Ignition Switch Tumbler in a BLACK or DARK GRAY Plug |
| EXTRA INFORMATION |
| NOTE *1 THE LIGHT GREEN (-) KEY SENSE WIRE AT THE STEERING COLUMN, MUST SEE A (-)NEGATIVE DURING REMOTE START TO KEEP THE SERVICE ENGINE LIGHT FROM COMING ON. SPLICE THE BANDED END OF A 1 AMP RECTIFIER DIODE(1N4004, FROM RADIO SHACK) TO THE NEGATIVE STATUS OUTPUT WIRE(SAME WIRE THAT RUNS TO YOUR BYPASS MODULE) FROM REMOTE STARTER, TAP UNBANDED END OF DIODE INTO THE KEYSENSE WIRE. NOTE *2 THE DRIVERS DOOR IS GRAY/BLACK (-).THE OTHER DOORS ARE BLACK/WHITE (-). BOTH WIRES ARE IN THE GRAY 24-PIN PLUG AT THE BCM. WHEN CONNECTING TO AN ALARM SYSTEM, USE BOTH DOOR TRIGGER WIRES AND DIODE ISOLATE, TO CONNECT, SEE DIAGRAM NOTE *3 ON THE 4 CYLINDER MODELS USE PURPLE/WHITE AT THE IGNITION MODULE ON THE DRIVERS SIDE OF THE MOTOR. ON THE 6 CYLINDER MODELS AT THE IGNITION COILS ON TOP OF THE CYLINDER HEAD ON THE DRIVERS SIDE OF THE MOTOR, USE ANY 1 OF THE 3 WIRES THAT IS NOT PINK OR BLACK. NOTE *4 THE BCM (Body Control Module) IS LOCATED ABOVE THE GLOVE BOX. |