| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | RED (+) | @ IGNITION SWITCH HARNESS |
| STARTER | YELLOW (+) | @ IGNITION SWITCH HARNESS |
| STARTER 2 | N/A | |
| IGNITION 1 | PINK (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 2 | N/A | |
| IGNITION 3 | N/A | |
| ACCESSORY/HEATER BLOWER 1 | ORANGE (+) | @ IGNITION SWITCH HARNESS |
| ACCESSORY/HEATER BLOWER 2 | N/A | |
| KEYSENSE | N/A | |
| PARKING LIGHTS ( - ) | N/A | |
| PARKING LIGHTS ( + ) | BROWN (+) | @ BCM, BLUE Plug, Pin A1, See NOTE #2 |
| POWER LOCK | LIGHT BLUE (TYPE C) See NOTE #3 | @ BCM, PURPLE Plug, Pin A4, See NOTE #2 |
| POWER UNLOCK | WHITE (TYPE C) See NOTE #3 | @ BCM, PURPLE Plug, Pin A3, See NOTE #2 |
| DOOR TRIGGER | See NOTE #4 | @ BCM, See NOTE #2 |
| DOMELIGHT SUPERVISION | WHITE (-) | @ BCM, BROWN Plug, Pin A1, See NOTE #2 |
| TRUNK RELEASE | WHITE/BLACK (-) | @ BCM, BLUE PLug, Pin B4, See NOTE #2 |
| SLIDING POWER DOOR | N/A | |
| HORN | BLACK (-) | @ BCM, BROWN Plug, Pin B7, See NOTE #2 |
| TACH | WHITE or ORANGE | @ IGNITION CONTROL Module, See NOTE #5 |
| WAIT TO START LIGHT | N/A | |
| BRAKE | WHITE (+) | @ SWITCH ABOVE BRAKE PEDAL |
| FACTORY ALARM DISARM | DISARMS with FACTORY REMOTE ONLY | |
| ANTI-THEFT | YELLOW (+) and BLACK (-) and WHITE (Not Used) | GM's PASSLOCK 2 System, wires are under the Steering Column cover, at the Bottom of the Ignition Switch Tumbler in a BLACK or DARK GRAY Plug |
| EXTRA INFORMATION |
| NOTE #1: This vehicle is equipped with PONTIAC'S PASSLOCK 2 ANTI-THEFT SYSTEM and will Require a Bypass Module for Remote Starting: To order this part 791 BYPASS MODULE, go to the SECURITY BYPASS MODULE Page on this website. NOTE #2: the BCM (Body Control Module) is located ABOVE the DRIVERS KICK PANEL. NOTE #3: if vehicle is NOT equipped with a FACTORY KEYLESS ENTRY, the Door Locks are a TYPE C with the wires located in each kick panel, you must use the Passenger Switch as the Master Switch. Vehicles with factory keyless are TYPE A Systems. NOTE #4: this vehicle has a GREEN/BLACK (-) Pin A7 for the DRIVERS DOOR and a LIGHT BLUE (-) Pin A8, for the PASSENGER DOOR(S) these wires are located at the BCM. When connecting to an ALARM SYSTEM, use both DOOR TRIGGER wires and DIODE ISOLATE. to connect, See DIAGRAM NOTE #5: the IGNITION CONTROL MODULE is located on the DRIVERS SIDE TOP of the ENGINE. |