NOTE #1: there are (2) PINK (+) wires that test as an Ignition wire, to test for the correct PINK IGNITION wire. Place the Key in the Ignition Switch but do not turn to the ON position. Try the remote starter, if the KEY in the IGNITION CHIME turns on, you are energizing the correct PINK Ignition wire.
NOTE #2: the BCM (Body Control Module) is located at the far end of the Drivers Dash, to access remove the Left END of the the Driver Dash it is just snapped into place then remove the under dash panel that is held into place with (3) plastic push-pins. Next remove the lower dash cover, this is held in place with (3) scres, one behind the Left END of the drives dash cover and (2) along the bottom of the dash. Next remove the Steel Knee bolster, it had (4) 10mm bolts that hould it into place on either side of the steering column. Now you can access the BCM, the BCM is hel into place by (3) 7mm screws on the face of the dash panel. The C2 54-pin connector for the BCM can be accessed from the Left END cover of the dash, the C1 54-pin connector and C3,18-PIN connector are side by side and are plugged into the BCM and face the floor of the vehicle, the C, 54-pin connector is to the left and the C3,18-PIN is to the right.
NOTE #3: the DRIVERS DOOR is a GRAY/BLACK (-) Pin 26, the PASSENGER DOOR is a BLACK/WHITE (-) Pin 17, the DRIVERS SIDE REAR DOOR is a LIGHT BLUE/BLACK (-) Pin 7 and the PASSENGERS SIDE REAR DOOR is a LIGHT GREEN/BLACK Pin 5 all are at the BCM Connector C2. When connecting to an ALARM SYSTEM, use all (4) DOOR TRIGGER wires and DIODE ISOLATE. to connect, See DIAGRAM
NOTE #4: the IGNITION CONTROL MODULE is located on the TOP of the ENGINE, towards the PASSENGER SIDE.
|