Oldsmobile  Silhouette 1997-1998
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   RED (+) and RED/WHITE (+)   IGNITION SWITCH HARNESS
 STARTER  YELLOW (+)  IGNITION SWITCH HARNESS
 STARTER 2  N/A  
 IGNITION 1  PINK (+)  IGNITION SWITCH HARNESS
 IGNITION 2  WHITE (+)  IGNITION SWITCH HARNESS
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  ORANGE (+)  IGNITION SWITCH HARNESS
 ACCESSORY/HEATER BLOWER 2  N/A  
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  N/A  
 PARKING LIGHTS ( + )  BROWN (+)  @ HEADLIGHT SWITCH
 POWER LOCK  LIGHT BLUE (TYPE B)  IN EITHER KICK PANEL
 POWER UNLOCK  WHITE (TYPE B)  IN EITHER KICK PANEL
 DOOR TRIGGER  See NOTE *1  @ BCM, See NOTE *2
 DOMELIGHT SUPERVISION  TAN (-)  @ BCM, See NOTE *2
 TRUNK RELEASE  N/A  
 SLIDING POWER DOOR  LIGHT BLUE (-) See NOTE *3  IN PASSNEGERS KICK PANEL
 HORN  BLACK (-)  @ STEERING COLUMN HARNESS
 TACH  PURPLE/WHITE or WHITE  @ MAIN HARNESS on DRIVERS SIDE of ENGINE
 WAIT TO START LIGHT  N/A  
 BRAKE  WHITE (+)  @ SWITCH ABOVE BRAKE PEDAL
 FACTORY ALARM DISARM   ORANGE/BLACK (-)  IN EITHER KICK PANEL or BCM, See NOTE *2
 ANTI-THEFT  N/A  
 EXTRA INFORMATION
 NOTE *1 this vehicle uses 3 wires, the TAN (-) is for the DRIVERS DOOR, the DARK BLUE (-) is for the PASSENGERS DOOR and the LIFTGATE, the ORANGE (-) is for the SLIDING DOORS, use a 3 wires and DIODE ISOLATE, when connecting to an ALARM SYSTEM, use all (3) DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM. NOTE *2 the BCM (Body Control Module) is located above the PASSENGER SIDE KICK PANEL. NOTE *3 a (-)Negative Pulse to the DARK BLUE (-) wire will open the Sliding Door, and another (-)Negative Pulse, to the same wires, will close the Sliding Door.