| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | RED (+) | IGNITION SWITCH HARNESS |
| STARTER | YELLOW (+) | IGNITION SWITCH HARNESS |
| STARTER 2 | N/A | |
| IGNITION 1 | PINK (+) | IGNITION SWITCH HARNESS |
| IGNITION 2 | WHITE (+) See NOTE *4 | IGNITION SWITCH HARNESS |
| IGNITION 3 | N/A | |
| ACCESSORY/HEATER BLOWER 1 | ORANGE (+) | IGNITION SWITCH HARNESS |
| ACCESSORY/HEATER BLOWER 2 | N/A | |
| KEYSENSE | N/A | |
| PARKING LIGHTS ( - ) | N/A | |
| PARKING LIGHTS ( + ) | BROWN (+) | @ BCM, LIGHT BLUE Plug, See NOTE *1 |
| POWER LOCK | LIGHT BLUE (TYPE A) | @ BCM, BROWN Plug, See NOTE *1 |
| POWER UNLOCK | WHITE (TYPE A) | @ BCM, BROWN Plug, See NOTE *1 |
| DOOR TRIGGER | See NOTE *2 | @ BCM, See NOTE *1 |
| DOMELIGHT SUPERVISION | TAN (-) | @ BCM, PURPLE Plug, Pin B4, See NOTE *1 |
| TRUNK RELEASE | BLACK (-) | @ BCM, PURPLE Plug, See NOTE *1 |
| SLIDING POWER DOOR | N/A | |
| HORN | BLACK (-) | @ BCM, BROWN Plug, See NOTE *1 |
| TACH | WHITE | @ PCM, See NOTE *3 |
| WAIT TO START LIGHT | N/A | |
| BRAKE | WHITE (+) | @ SWITCH ABOVE BRAKE PEDAL |
| FACTORY ALARM DISARM | LIGHT GREEN (-) | @ BCM, PURPLE Plug, See NOTE *1 |
| ANTI-THEFT | YELLOW (+), ORANGE/BLACK (-) and RED/WHITE (Not used) | GM's PASSLOCK 2 System, these wires exit the Ignition Switch Tumbler together and are in the Main Ignition Switch Harness in the Column. |
| EXTRA INFORMATION |
| NOTE *1 the BCM (Body Control Module) is located to the RIGHT of the Gas Pedal, attached to the Heater box. The BCM has 3 Plugs that face the Drivers side of the Vehicle. On the BCM is printed the colors of the 3 plugs, PURPLE, BLUE and BROWN NOTE *2 the DRIVERS DOOR is a TAN (-) Pin B4, PURPLE Plug at the BCM, the PASSENGER DOOR is a ORANGE (-) Pin B2 of the PURPLE Plug, the REAR DOORS and the REAR HATCH is a DARK BLUE/WHITE (-) Pin B11 in the LIGHT BLUE Plug of the BCM. When connecting to an ALARM SYSTEM, use all 3 DOOR TRIGGER wires and DIODE ISOLATE. to connect, See DAIGRAM NOTE *3 the PCM (Powertrain Control Module) is located on the PASSENGER FENDER. NOTE *4 IMPORTANT !!!!! this wire MUST BE CONNECTED as IGNITION #2 for REMOTE STARTING!!!!!! |