Nissan Titan 2007-2011 Printer Friendly Wiring Chart

Nissan Titan 2007-2011

PART	COLOR	LOCATION
12 VOLT CONSTANT	GREEN (+)	@ IGNITION SWITCH, (WHITE, 6-PIN LUG), PIN 3
STARTER	BROWN (+)	@ IGNITION SWITCH, (WHITE, 6-PIN LUG), PIN 2
STARTER 2	LT. GREEN (+)	@ IGNITION SWITCH, (WHITE, 6-PIN LUG), PIN 6
IGNITION 1	BLACK/RED (+)	@ IGNITION SWITCH, (WHITE, 6-PIN LUG), PIN 1
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	RED (+)	@ IGNITION SWITCH, (WHITE, 6-PIN LUG), PIN 4
ACCESSORY/HEATER BLOWER 2	PURPLE (+)	@ IGNITION SWITCH, (WHITE, 6-PIN LUG), PIN 5
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	RED/BLUE (+)	@ ELECTRIC BRAKE Pre-wiring Harness, (WHITE, 6-PIN PLUG), PIN 4, NOTE #5
POWER LOCK	BLUE (TYPE B), NOTE #3	@ POWER WINDOW Main Switch, (WHITE, 16-PIN PLUG), PIN 6 or 4
POWER UNLOCK	RED (TYPE B), Requires Double Pulse, NOTE #4	@ POWER WINDOW Main Switch, (WHITE, 16-PIN PLUG), PIN 7 or 6
DOOR TRIGGER	LT. BLUE (-)	in DRIVERS KICK PANEL or BCM, (BLACK, 15-PIN PLUG), PIN 10, NOTE #2
DOMELIGHT SUPERVISION	BLUE (-)	@ DRIVERS KICK A Pillar or BCM, (BLACK, 15-PIN PLUG), PIN 8, NOTE #2
TRUNK RELEASE	N/A
SLIDING POWER DOOR	N/A
HORN	RED/WHITE (-)	@ HORN Switch, (GRAY, 8-PIN PLUG), PIN 2, Under Steering Column cover
TACH	Any wire NOT WHITE (AC)	@ Any FUEL-INJECTOR
WAIT TO START LIGHT	N/A
BRAKE	RED/GREEN to RED/BLACK (+)	@ BRAKE PEDAL Switch or in PASSENGER KICK PANEL, Harness to REAR of vehicle
FACTORY ALARM DISARM	Use UNLOCK wire
ANTI-THEFT	NISSAN'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1

EXTRA INFORMATION

NOTE #1: This vehicle is Equipped with NISSAN'S TRANSPONDER ANTI-THEFT SYSTEM, for REMOTE STARTING ONLY you will need the Part #791 BYPASS Module and an Extra Ignition key. (Requires extra key for Operation) Part # XK09 for REMOTE STARTING ONLY, requires 1 key for programming, NO key required for Operation. Part # DB-ALL for REMOTE START/KEYLESS Entry, requires 1 key for programming and NO Key for Operation. To Order the go to the SECURITY BYPASS MODULE Page or INTERFACE BYPASS MODULE Page on this website. NOTE #2: the BCM (Body Control Module) is located under the Drivers Dash and to the RIGHT of the Steering Column. NOTE #3: TEST this wire while Turning the KEY in the Drivers Door. This wire will also ARM the FACTORY ALARM. NOTE #4: TEST this wire while Turning the KEY in the Drivers Door. This wire will also DISARM the FACTORY ALARM. NOTE #5: the ELECTRIC BRAKE Pre-wiring Harness is located Under the DRIVERS DASH, and to the RIGHT of the STEERING COLUMN.