| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | GREEN (+) | IGNITION SWITCH HARNESS |
| STARTER | BLACK/RED (+) See NOTE *1 | IGNITION SWITCH HARNESS |
| STARTER 2 | BLACK/YELLOW (+) See NOTE *1 | IGNITION SWITCH HARNESS |
| IGNITION 1 | BLACK/WHITE (+) | IGNITION SWITCH HARNESS |
| IGNITION 2 | N/A | |
| IGNITION 3 | N/A | |
| ACCESSORY/HEATER BLOWER 1 | RED (+) | IGNITION SWITCH HARNESS |
| ACCESSORY/HEATER BLOWER 2 | WHITE/RED (+) | IGNITION SWITCH HARNESS |
| KEYSENSE | N/A | |
| PARKING LIGHTS ( - ) | N/A | |
| PARKING LIGHTS ( + ) | RED/BLUE (+) | IN DRIVERS KICK PANEL, HARNESS to REAR of VEHICLE |
| POWER LOCK | BLUE (TYPE B) | @ MODULE IN DRIVERS DOOR |
| POWER UNLOCK | RED (TYPE B) (Requires Double Pulse) | @ MODULE IN DRIVERS DOOR |
| DOOR TRIGGER | PINK (-) | @ DOMELIGHT SWITCH, LEFT OF STEERING COLUMN |
| DOMELIGHT SUPERVISION | TURNS ON with UNLOCK | |
| TRUNK RELEASE | GREEN/RED (-), Requires Part #775 Relay | @ HATCH RELEASE SWITCH |
| SLIDING POWER DOOR | BLUE/WHITE(-) (LEFT Door) GREEN/WHITE (RIGHT Door) (-) See NOTE *3 | IN DRIVERS SIDE A PILLAR |
| HORN | GREEN/WHITE (-) | @ STEERING COLUMN HARNESS |
| TACH | ANY WIRE NOT RED or BLACK | @ ANY IGNITION COIL |
| WAIT TO START LIGHT | N/A | |
| BRAKE | RED/GREEN (+) | @ SWITCH ABOVE BRAKE PEDAL |
| FACTORY ALARM DISARM | DISARMS WITH UNLOCK, Single Pulse Disarms | |
| ANTI-THEFT | TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY | TRANSPONDER @ IGNITION SWITCH TUMBLER |
| EXTRA INFORMATION |
| NOTE *1 When Installing a REMOTE STARTER, you MUST use BOTH Starter #1 and Starter #2 wires. Both wires must be connected to the STARTER/CRANKING Output wire from the Remote Starter or the vehcile will NOT Remote Start when the Engine is cold. NOTE *2 THE BCM (Body Control Module) IS LOCATED UNDER THE DRIVERS SIDE OF THE DASH. NOTE *3 To operate the Sliding Door function will require a extra relay Part #775 for each sliding door, to connect, See DIAGRAM. |