PART | COLOR | LOCATION |
12 VOLT CONSTANT | LIGHT GREEN/PURPLE (+) | @ IGNITION SWITCH HARNESS |
STARTER | RED/LIGHT BLUE (+) | @ IGNITION SWITCH HARNESS |
STARTER 2 | N/A | |
IGNITION 1 | RED/LIGHT GREEN (+) | @ IGNITION SWITCH HARNESS |
IGNITION 2 | BLACK/LIGHT GREEN (+) | @ IGNITION SWITCH HARNESS |
IGNITION 3 | N/A | |
ACCESSORY/HEATER BLOWER 1 | GREY/YELLOW (+) | @ IGNITION SWITCH HARNESS |
ACCESSORY/HEATER BLOWER 2 | N/A | |
KEYSENSE | N/A | |
PARKING LIGHTS ( - ) | N/A | |
PARKING LIGHTS ( + ) | BROWN (+) | @ SMJ, BOTTOM plug, Pin 31, See NOTE *1 |
POWER LOCK | PINK/YELLOW (TYPE B) | @ GEM, 26 Pin Plug, Pin 18, See NOTE *2 |
POWER UNLOCK | PINK/LIGHT GREEN (TYPE B) | @ GEM, 26 Pin Plug, Pin 6, See NOTE *2 |
DOOR TRIGGER | See NOTE *3 | @ GEM, 26-Pin Plug, See DIAGRAM |
DOMELIGHT SUPERVISION | BLACK/LIGHT BLUE (+) | @ SJB, TOP Plug, Pin 22, See NOTE *1 |
TRUNK RELEASE | PURPLE/YELLOW (+) | @ GEM, 26 Pin Plug, Pin 3, See NOTE *2 |
SLIDING POWER DOOR | N/A | |
HORN | DARK BLUE (-) | @ SJB, BOTTOM Plug, Pin 1, See NOTE *1 |
TACH | Any wire that is NOT RED | @ IGNITION COIL or FUEL INJECTOR |
WAIT TO START LIGHT | N/A | |
BRAKE | RED/LIGHT GREEN (+) | @ SWITCH ABOVE BRAKE PEDAL |
FACTORY ALARM DISARM | PINK/WHITE (-) | @ GEM, 26 Pin PLug, PIN 4, See NOTE *2 |
ANTI-THEFT | FORD'S SECURILOCK ANTI-THEFT TRANSPONDER SYSTEM | @ IGNITION SWITCH TUMBLER |
EXTRA INFORMATION |
NOTE *1 the SJB (Smart Junction Block) is part of the FUSE/RELAY box to the LEFT of the Steering Column, it has (3) three plugs to the LEFT of the fuses. NOTE *2 the GEM (Generic Electronic Control) Module is part of the SJB (See NOTE *1) NOTE *3 the DRIVERS DOOR is a YELLOW/BLACK(-) Pin 5, the PASSENGER DOOR is a GRAY/RED(-) Pin 19, the DRIVERS REAR DOOR is a LIGHT GREEN/YELLOW(-) Pin 20 and the PASSENGER REAR DOOR is a PINK/LIGHT BLUE(-) Pin 7. When connecting to an ALARM SYSTEM, use all 4 Door Trigger wires and DIODE ISOLATE, to connect, See DIAGRAM NOTE #4: This vehicle is equipped with a Special Anti-theft key, to remote start you will need a Bypass module 791, use this module IF you have a extra ignition key to place inside the 791 to remote start, if you do not have an extra key to use or wish not to have a key placed inside this bypass module, we OFFER a KEYLESS INTERFACE BYPASS MODULE that does not require a key to be placed inside the bypass module, this is Part # PKALL or PKFM, either one will work, to order, go to the INTERFACE BYPASS MODULE PAGE on this website. |