| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | LIGHT GREEN/PURPLE (+) or YELLOW (+) | @ IGNITION SWITCH HARNESS |
| STARTER | RED/LIGHT BLUE (+) | @ IGNITION SWITCH HARNESS |
| STARTER 2 | N/A | |
| IGNITION 1 | RED/LIGHT GREEN (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 2 | RED/BLACK (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 3 | N/A | |
| ACCESSORY/HEATER BLOWER 1 | GRAY/YELLOW (+) | @ IGNITION SWITCH HARNESS |
| ACCESSORY/HEATER BLOWER 2 | BLACK/LIGHT GREEN (+) | @ IGNITION SWITCH HARNESS |
| KEYSENSE | N/A | |
| PARKING LIGHTS ( - ) | N/A | |
| PARKING LIGHTS ( + ) | BROWN (+) | @ HEADLIGHT SWITCH or FUSEBOX |
| POWER LOCK | PINK/YELLOW (TYPE B) | IN DRIVERS KICK PANEL |
| POWER UNLOCK | PINK/LIGHT GREEN (TYPE B) | IN DRIVERS KICK PANEL |
| DOOR TRIGGER | BLACK/LIGHT BLUE (+) | @ UNDER DASH LIGHT |
| DOMELIGHT SUPERVISION | USE DOOR TRIGGER, Requires Part #775 Relay | |
| TRUNK RELEASE | See NOTE *1, Requires Part #775 Relay | @ TRUNK RELEASE SWITCH |
| SLIDING POWER DOOR | N/A | |
| HORN | PURPLE/ORANGE (-) | See NOTE *2 |
| TACH | YELLOW/WHITE (AC) | @ IGNITION COIL |
| WAIT TO START LIGHT | N/A | |
| BRAKE | RED/LIGHT GREEN (+) | @ SWITCH ABOVE BRAKE PEDAL |
| FACTORY ALARM DISARM | PINK/WHITE (-) | IN DRIVERS KICK PANEL |
| ANTI-THEFT | FORD'S PATS ANTI-THEFT (Some Vehicles) TRANSPONDER SYSTEM | @ IGNITION SWITCH TUMBLER |
| EXTRA INFORMATION |
| NOTE *1 there are 2 wires at the TRUNK RELEASE SWITCH, if the switch has a PINK/YELLOW and a GRAY/RED, use the PINK/YELLOW, wire the unit for a (-) NEGATIVE TRUNK RELEASE. If the switch has a GRAY/RED and a PURPLE/YELLOW, use the GRAY/RED, wire the unit for a (+) POSITIVE TRUNK RELEASE. NOTE *2 this (-) PURPLE/ORANGE Horn wire, is located in a 4-Pin plug, to the RIGHT of the STEERING COLUMN. NOTE #3: This vehicle is equipped with a Special Anti-theft key, to remote start you will need a Bypass module 791, use this module IF you have a extra ignition key to place inside the 791 to remote start, if you do not have an extra key to use or wish not to have a key placed inside this bypass module, we OFFER a KEYLESS INTERFACE BYPASS MODULE that does not require a key to be placed inside the bypass module, this is Part # PKALL or PKFM, either one will work, to order, go to the INTERFACE BYPASS MODULE PAGE on this website. |