| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | YELLOW (+), BROWN (+) and GREEN (+) | @ IGNITION SWITCH HARNESS |
| STARTER | WHITE/PINK (+) | @ IGNITION SWITCH HARNESS |
| STARTER 2 | N/A | |
| IGNITION 1 | BROWN/PINK (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 2 | PINK/BLACK (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 3 | N/A | |
| ACCESSORY/HEATER BLOWER 1 | GRAY/YELLOW (+) | @ IGNITION SWITCH HARNESS |
| ACCESSORY/HEATER BLOWER 2 | BLACK/GREEN (+) | @ IGNITION SWITCH HARNESS |
| KEYSENSE | N/A | |
| PARKING LIGHTS ( - ) | N/A | |
| PARKING LIGHTS ( + ) | BROWN (+) | IN DRIVERS KICK PANEL |
| POWER LOCK | PINK/YELLOW (TYPE C), See NOTE #1 | IN DRIVERS KICK PANEL |
| POWER UNLOCK | PINK/LIGHT GREEN (TYPE C), See NOTE #1 | IN DRIVERS KICK PANEL |
| DOOR TRIGGER | DARK BLUE (-) and BLACK/ORANGE (-) Use both, See NOTE #5 | @ LCM Module, See NOTE #2 |
| DOMELIGHT SUPERVISION | DARK BLUE (-), (Requires #775 Relay) | @ LCM Module, See NOTE #2 |
| TRUNK RELEASE | PURPLE/YELLOW (5-Wire), See NOTE #3, (Requires Part #775 Relay) | IN DRIVERS DOOR HARNESS |
| SLIDING POWER DOOR | N/A | |
| HORN | YELLOW/LIGHT GREEN (-) | @ STEERING COLUMN HARNESS |
| TACH | See NOTE #4 | @ IGNITION COIL PACK |
| WAIT TO START LIGHT | N/A | |
| BRAKE | LIGHT GREEN (+) | @ SWITCH ABOVE BRAKE PEDAL |
| FACTORY ALARM DISARM | DARK GREEN/PURPLE (-) | IN DRIVERS KICK PANEL |
| ANTI-THEFT | N/A |
| EXTRA INFORMATION |
| NOTE #1: If vehicle is equipped with a FACTORY KEYLESS ENTRY System, then the vehicle has a TYPE B Door Locking System, vehicles without FACTORY KEYLESS ENTRY, have a TYPE C Door Locking System. Vehicles with the KEY PAD on the Door are considered to have KEYLESS ENTRY. NOTE #2: the LCM (Lighting Control Module) is located under the drivers side dash. NOTE #3; this vehicle uses a 5-wire TRUNK Release System that requires an extra relay part #775, to connect, See DIAGRAM NOTE #4; the TACH wire on this vehicle at the coil pack is a TAN/LIGHT GREEN, TAN/LIGHT BLUE, TAN/WHITE or TAN/ORANGE. (AC) NOTE #5: when connecting to an ALARM SYSTEM, use both DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM |