PART | COLOR | LOCATION |
12 VOLT CONSTANT | RED (+) | @ IGNITION SWITCH HARNESS |
STARTER | GRAY/WHITE (+) | @ IGNITION SWITCH HARNESS |
STARTER 2 | N/A | |
IGNITION 1 | GREEN (+) | @ IGNITION SWITCH HARNESS |
IGNITION 2 | N/A | |
IGNITION 3 | N/A | |
ACCESSORY/HEATER BLOWER 1 | YELLOW (+) | @ IGNITION SWITCH HARNESS |
ACCESSORY/HEATER BLOWER 2 | N/A | |
KEYSENSE | N/A | |
PARKING LIGHTS ( - ) | BLACK/YELLOW (-) | @ KEYLESS ENTRY MODULE, See NOTE #2 |
PARKING LIGHTS ( + ) | RED/BLUE (+) and RED/YELLOW (+) Use both, See NOTE #3 | @ HEADLIGHT SWITCH, See DIAGRAM |
POWER LOCK | YELLOW/GREEN (TYPE B) | IN DRIVERS KICK PANEL |
POWER UNLOCK | WHITE/GREEN (TYPE B) | IN DRIVERS KICK PANEL |
DOOR TRIGGER | BLACK/RED (-) and BLACK/GREEN (-) Use both, See NOTE #4 | @ TOP of FUSEBOX |
DOMELIGHT SUPERVISION | BLACK/BLUE (-), (Requires Part #775 Relay) | @ DRIVER A PILLAR |
TRUNK RELEASE | BLACK/YELLOW (-), (Requires Part #775 Relay) | @ TRUNK RELEASE SWITCH or in DRIVERS KICK PANEL |
SLIDING POWER DOOR | N/A | |
HORN | BLACK/BLUE (-) | @ STEERING COLUMN HARNESS |
TACH | BROWN/GREEN (AC) | @ IGNITION COIL PACK |
WAIT TO START LIGHT | N/A | |
BRAKE | ORANGE/BLUE (+) | @ SWITCH ABOVE BRAKE PEDAL |
FACTORY ALARM DISARM | BLACK/WHITE (-) | IN DRIVERS KICK PANEL |
ANTI-THEFT | FORD'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 | @ IGNITION SWITCH TUMBLER |
EXTRA INFORMATION |
NOTE #1: This vehicle MAY BE equipped with a Special Anti-theft key, to remote start you will need a Bypass module 791, use this module IF you have a extra ignition key to place inside the 791 to remote start, if you do not have an extra key to use or wish not to have a key placed inside this bypass module, we OFFER a KEYLESS INTERFACE BYPASS MODULE that does not require a key to be placed inside the bypass module, this is Part # PKALL or PKFM, either one will work, to order, go to the INTERFACE BYPASS MODULE PAGE on this website. NOTE #2: the FACTORY KEYLESS ENTRY Module is located behind the GLOVE BOX, this wire flashes the hazard lights. NOTE #3; these wires must be isolated with 2 relay part #775, so that the headlights do not operate with the parking lights. See DIAGRAM. NOTE #4: the BLACK/RED (-) is for the drivers door, and the BLACK/GREEN (-) is for the passenger door, when connecting to an ALARM SYSTEM us both wires and DIODE ISOLATE. For Dome Light Supervision use the BLACK/RED (-) is for the drivers door. To get to these wires, pull the fuse panel down and remove the cover. |