| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | RED (+) | IGNITION SWITCH HARNESS, See NOTE *1 |
| STARTER | PURPLE (+) | IGNITION SWITCH HARNESS, See NOTE *1 |
| STARTER 2 | N/A | |
| IGNITION 1 | PINK/BLACK (+) | IGNITION SWITCH HARNESS, See NOTE *1 |
| IGNITION 2 | PINK/YELLOW (+) | IGNITION SWITCH HARNESS, See NOTE *1 |
| IGNITION 3 | N/A | |
| ACCESSORY/HEATER BLOWER 1 | PINK/GREEN (+) | IGNITION SWITCH HARNESS See NOTE *1 |
| ACCESSORY/HEATER BLOWER 2 | N/A | |
| KEYSENSE | N/A | |
| PARKING LIGHTS ( - ) | N/A | |
| PARKING LIGHTS ( + ) | GRAY (+) and GRAY/WHITE (+) See NOTE *2 | @ HEADLIGHT SWITCH |
| POWER LOCK | BLUE/YELLOW (TYPE B) | IN EITHER KICK PANEL |
| POWER UNLOCK | BLUE/BLACK (TYPE B) | IN EITHER KICK PANEL |
| DOOR TRIGGER | BROWN/GRAY (-) and BROWN/RED (-) Use both, See NOTE *3 | @ PIN SWITCHES |
| DOMELIGHT SUPERVISION | BROWN/GRAY (-) | @ DRIVERS PIN SWITCH |
| TRUNK RELEASE | N/A | |
| SLIDING POWER DOOR | N/A | |
| HORN | BLACK/YELLOW/RED (+) | @ THEFT MODULE, See NOTE *4 |
| TACH | BLACK | @ IGNITION COIL |
| WAIT TO START LIGHT | N/A | |
| BRAKE | BLACK/RED/WHITE (+) | @ SWITCH ABOVE BRAKE PEDAL |
| FACTORY ALARM DISARM | BROWN/YELLOW (-) | @ THEFT MODULE, See NOTE *4 |
| ANTI-THEFT | TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY | TRANSPONDER @ IGNITION SWITCH TUMBLER |
| EXTRA INFORMATION |
| NOTE *1 Remove the KNEE BOLSTER from dash to access the IGNITION SWITCH HARNESS. NOTE *2 this vehicle uses 2 parking Light wires, to connect will require 2 extra relays Part #775, to connect, See DIAGRAM NOTE *3 the BROWN/GRAY(-) wire is at the Drivers pin switch and the BROWN/RED (-) wire is at the Drivers Rear Pin switch. You can also use the WHITE/PINK (-) for the front doors and the for the BROWN/PINK (-) for Rear doors at the THEFT MODULE in the trunk. When connecting to an ALARM SYSTEM, use all 4 DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM NOTE *4 the THEFT MODULE is located in the trunk behind the liner on the Right side. |