NOTE #1: This vehicle is with MAZDA'S TRANSPONDER ANTI-THEFT SYSTEM,
for REMOTE STARTING ONLY you will need the Part #791 BYPASS Module and an
Extra Ignition key. (Requires extra key for Operation)
Part # PK-ALL or PKFM for REMOTE STARTING ONLY, requires 2 keys for
programming, NO key required for Operation.
Part # DB-ALL for Remote Starting and Keyless Entry operation (no resistors
required), 2 keys required for programming, no key required for Operation.
To Order the go to the SECURITY BYPASS MODULE Page or INTERFACE BYPASS
MODULE Page on this website.
NOTE #2: The KCM (Keyless Control Module) is located under the Drivers Dash
NOTE #3: This Vehicle uses a 1-Wire Door Locking System, it Requires (-) thru a 1000 Ohm
Resistor to Lock and a (-) to Unlock.
NOTE #4: this Vehicle uses a 1-Wire ARM/DISARM System, it Requires (-) thru a 1000 Ohm
Resistor to DISARM the Factory Alarm System.
NOTE #5: TEST this wire while Opening the Trunk/Liftgate from the Release Button on the
REAR of the Vehicle.
NOTE #6: On vehicles with the PUSH-BUTTON Start, this wire is at the KCM, (GRAY, 27-PIN
PLUG), PIN B. The KCM (Keyless Control Module) is located under the Drivers Dash
NOTE #7: On vehicles with the PUSH-BUTTON Start, this wire is a PINK/BLUE (+)located at the
RELAY BLOCK, (6-PIN PLUG), PIN B. The RELAY BLOCK is located under the DRIVERS
DASH, close to the Steering Column.
NOTE #8: On vehicles with the PUSH-BUTTON Start, this wire is located at the RELAY BLOCK,
(6-PIN PLUG), PIN F. The RELAY BLOCK is located under the DRIVERS DASH and to
the LEFT of the Steering Column.
NOTE #9: On vehicles with the PUSH-BUTTON Start, this wire is located at the RELAY BLOCK,
(8-PIN PLUG), PIN B. The RELAY BLOCK is located under the DRIVERS DASH and to
the LEFT of the Steering Column.
|