PART | COLOR | LOCATION |
12 VOLT CONSTANT | BLACK (+) | @ IGNITION SWITCH HARNESS |
STARTER | BLACK/BLUE (+) | @ IGNITION SWITCH HARNESS |
STARTER 2 | N/A | |
IGNITION 1 | BLUE (+) | @ IGNITION SWITCH HARNESS |
IGNITION 2 | N/A | |
IGNITION 3 | N/A | |
ACCESSORY/HEATER BLOWER 1 | BLACK/RED (+) | @ IGNITION SWITCH HARNESS |
ACCESSORY/HEATER BLOWER 2 | PURPLE (+) | @ IGNITION SWITCH HARNESS |
KEYSENSE | N/A | |
PARKING LIGHTS ( - ) | BROWN/RED (-) | @ HEADLIGHT SWITCH or BCM, 30-Pin, Pin 30, See NOTE #2 |
PARKING LIGHTS ( + ) | GRAY/BLACK (+) | in DRIVERS KICK PANEL or BCM, 16-Pin Plug, Pin 1B, See NOTE #2 |
POWER LOCK | BLUE (1-Wire Door Locking System) See NOTE #3 | in DRIVERS KICK PANEL or BCM, 24-Pin Plug, Pin 5I,See NOTE #2, See DIAGRAM |
POWER UNLOCK | Same wire! | See DIAGRAM |
DOOR TRIGGER | See NOTE #4 | @ BCM, 24-Pin Plug, See NOTE #2 |
DOMELIGHT SUPERVISION | YELLOW (-) | in DRIVERS KICK PANEL or BCM, 8-Pin Plug, Pin 6I, See NOTE #2 |
TRUNK RELEASE | N/A | |
SLIDING POWER DOOR | N/A | |
HORN | PURPLE/WHITE (-) | @ HORN SWITCH or BCM, 30-Pin PLug, Pin 3Y, See NOTE #2 |
TACH | Any wire NOT BLACK/GREEN, BLACK or GREEN/BLUE | @ Any FUEL-INJECTOR or Ignition Coil |
WAIT TO START LIGHT | N/A | |
BRAKE | GREEN/YELLOW (+) | @ Switch above Brake Pedal |
FACTORY ALARM DISARM | LIGHT GREEN/RED (-) | in DRIVERS KICK PANEL or BCM, 24-Pin Plug, Pin 5Q, See NOTE #2 |
ANTI-THEFT | MAZDA'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 | @ IGNITION SWITCH TUMBLER |
EXTRA INFORMATION |
NOTE #1: This vehicle is with MAZDA'S TRANSPONDER ANTI-THEFT SYSTEM, for REMOTE STARTING ONLY you will need the Part #791 BYPASS Module and an Extra Ignition key. (Requires extra key for Operation) Part # PK-ALL or PKFM for REMOTE STARTING ONLY, requires 2 keys for programming, NO key required for Operation. Part # DB-ALL for Remote Starting and Keyless Entry operation (no resistors required), 2 keys required for programming, no key required for Operation. To Order the go to the SECURITY BYPASS MODULE Page or INTERFACE BYPASS MODULE Page on this website. NOTE #2: The BCM is located behind the GLOVE BOX. NOTE #3: LOCK requires a (-) Negative thru a 1000 Ohm Resistor and UNLOCK requires a straight (-) Negative, to connect See DIAGRAM. NOTE #4: The DRIVERS DOOR Trigger is a BLUE/BLACK (-) at Pin 5G, the PASSENGER DOOR Trigger RED/YELLOW at Pin 5E. The REAR SLIDING DOORS are GREEN/ORANGE (-) at Pin 5C.When connecting to an ALARM System, use all 3 wires See DIAGRAM |